Before starting
your dishwasher
1. Spin the Upper Spray Arm to make sure
nothing will stop it from turning freely
2. Push door firmly when closing and it will
automatically latch.
3. Run hot water at sink nearest dishwasher
until it is hot. Turn it off.
Starting your dishwasher
1. Push a Clean Selector Button for the de- - POTS & PANS and HEAVY WASH Cycles
sired cycle. share the same spot on the dial. The
2. Push Option Selector Button for desired Clean Selector Button determines
option or options. (Use AIR DRY for RINSE which cycle operates.
& HOLD Cycle.) The dishwasher will automatically start
3. Turn Cycle Control Knob clockwise to that cycle.
point to a desired cycle. You will feel a
definite stop at each cycle mark.
The AIR DRY Option
Air in the dishwasher is automatically heated Some items (such as plastics) may need towel
during the ?dry? part of all cycles, drying.
If the AIR DRY Option is selected, air in the For best results, use a liquid rinse aid such as
dishwasher is not heated. Using this option helps Jet-Dry?
save energy, but dishes take longerto dry [over-
night] and some water spotting may result.
HI-TEMP WASHING Option
If the water is already hot enough, the cycle
When this option is selected, water for the continues without delay. The WATER HEATING
main wash and the final rinse is heated to145?F HOLD Signal Light will be on while the cycle de-
(63°C). lays for water heating.
Changing a setting
You can change a setting anytime during 3. Be sure the detergent dispensers are filled
any cycle. properly for the new cycle.
1. Press in the door latch to unlatch the door 4. Close and latch the door. The dishwasher will
and stop the cycle. automatically start the new cycle.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
To add a dish after starting
1. To be sure the added item is washed and 4. Close the door. Do not latch it. Wait 30 sec-
rinsed, make sure the Cycle Control Knob onds for air in the dishwasher to warm up.
has not passed LOW ENERGY WASH. Thus helps reduce the amount of moisture
that can come from the vent when restart-
2. Unlatch the doorto stop the cycle.
3. Open the door and add the dish. ing the cycle.
5. Latch the door. The dishwasher will start
from where it stopped.
The CLEAN Signal Light
The CLEAN Signal Light will come on when a To turn it off. Turn the Control Knob clockwise
washing cycle is complete. slightly until the light goes off. |
ACEC
