POWER CLEAN?? Washing System
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent against
soiled surfaces of dishes, When a cycle is started, the dishwasher fills with water to about the
level of the heating element. This water is pumped through the rotating spray arms, through
the POWER CLEAN* Module which removes food particles, and back through the rotating
spray arms. Soiled water is pumped out and replaced with clean water during a cycle-the
number of times depends on the cycle being used.
The POWER CLEAN* Module removes food
particles from the water, stores them, then
washes them down the drain.
Load dishes so soiled surfaces face pow-
erful spray from rotating arms.
Step-saving preparation for washing
It Is not necessary to rinse dishes before might hear chopping, grinding, crunching or
putting them Into the dishwasher. Just remove buzzing sounds. Those sounds are normal when
large pieces, bones, and other hard items. The hard items enter the module. DO NOT LET
POWER CLEAN? Module will remove food parti- METALLIC ITEMS (I.E. POT HANDLE SCREWS)
cles from the water. It contains a chopping de- GET INTO THE POWER CLEAN* MODULE. THIS
vice which will reduce the size of food items. COULD RESULT IN DAMAGE TO THE POWER
If hard items such as fruit seeds, nuts and egg CLEAN* MODULE.
shells enter the POWER CLEAN? Module, you
Hot water is a must
Hot water dissolves and activates the dish- the temperature is too low, have a qualified
washing detergent. Hot water dissolves grease person raise the water heater thermostat
on dishes and helps dry glasses spot-free. Make setting.
certain loads are washed in hot water [at least
140°F - 60°C). Two ways to have a reliable hot 2. Use HI-TEMP WASH Option. If water heating is
needed, a thermostat will delay the cycle un-
water supply... til temperature reaches 145? (63°C). If water is
1. Maintain 140°F water supply at central water hot enough, the cycle will proceed with no
heater. To check water temperature, turn on delay. This lets you turn down your wafer
hot water faucet nearest the dishwasher. Let heater, if you choose, without cutting back on
water run until it is as hot as possible, then hot water needed for good dishwashing.
check with a candy or meat thermometer. If
Quiet operating tips
To avoid thumping and clattering noises during or interfere with either of the spray arms
operation: rotation.
l Make sure lightweight load items are secured l Load dishes so they don?t touch one another.
in the rack. NOTE: Keep sink drain plugs inserted during
l Make sure pot lids and handles, pizza pans, dishwasher operation to prevent noise trans-
cookie sheets, etc. do not touch interior walls ter through dmlns. ?Tmk
4 |
ACEC
