PROBLEM CAUSED BY SOLUTION
Dishes not Water is not Water temperature should be at least 14O?F [bO?C). Set
washlng clean hot enough water heater thermostat to a higher setting. Run water at
sink until hot before starting and/or use HI-TEMP WASH
Option.
Improper loading Make sure dishes and glassware are loaded so spray
reaches all surfaces and items drain properly. Do not ov-
erload. Do not nest items.
Make sure large items do not block spray from reaching
detergent dispensers.
Spray arm or arms not Check spray arms to make sure they turn freely after load-
rotating freely ing. Be sure a utensil has not prevented their turning.
Not enough detergent Use more dishwasher detergent. Use detergent with high-
or improper est available phosphorus content...especially with hard
detergent water
?0ld?detergent Use only fresh dishwasher detergent. Store tightly closed
container in cool, dry place. Discard old detergent. Do not
fill dispensers until ready to start dishwasher.
Water pressure may If water pressure is low, do not use water for other purposes
be low, dishwasher is while dishwasher is running (to assure correct fills).
not filling properly
Cloudy tllm on Too much detergent Check for rainbow hue on glasses. A rainbow hue is the
glassware, in soft water first sign of etching [corrosion of glass). Reduce the amount
etching - of dishwasher detergent. Use a detergent with a lower
permanent phosphorus content.
corrosion Inadequate rinsing If water pressure is low do not use water for other purposes
while dishwasher is running [to assure correct water fills).
Make sure dishes and glassware are loaded properly to
assure adequate rinsing and draining. Do not overload.
Dishes & Iron or manganese in Temporary remedy:
lnterlor of water I. Set empty dishwasher for a ?one wash? cycle.
dlshwasher
yellow or 2. Start dishwasher and unlatch door to stop it when it has
brown filled for the wash part of the cycle.
3. Add % to % CUD 1120 to 240 mLl of citric acid crvstals
(usually available in drugstoresj.
4. Close and latch door to complete cycle.
Permanent solution: Install an iron or manganese filter to
home water supply.
Rust spots on Allowing salty or Rinse flatware that is to stand for several hours before
stalnless steel acidic foods such as washing [use Rinse & Hold]. Clean stained items with silver
-OR- mayonnaise, vinegar, polish and re-wash. Do not put stalnless steel and sliver
Dark spots on fruit juices, salad flatware In the same sllverware basket compartment.
flatware - dressings, milk Direct contact between these metals can cause perma-
stalnless steel, products to remain on nent damage to the sliver.
sliver plate, or flatware.
sterling Undissolved Remove spots with silver polish. Avoid spilling concentrated
detergent coming in detergent on wet flatware.
contact with flatware
Bronze tarnish Silverplate is worn off Remove tarnish with silver polish. Have silver replated
on sllverplate Exposed base metal
takes on a bronzed
hue.
Water lett In Dishwasher cycle not Allow dishwasher to complete cycle
bottom ot completed
dlshwasher Some plumbing codes require use of a drain air gap be-
Clogged drain air
gap tween an undercounter dishwasher and the drain system of
the house. The air gap is usually located above the sink or
on the top of the counter near the dishwasher to prevent the
possibility of water backing up from the drain into the dish-
washer due to a plugged drain. The drain air gap is NOT a
part of the dishwasher and is NOT covered by the dish-
washer warranty. The drain air gap should be kept clean to
ensure proper draining of the dishwasher. |
ACEC
