Connecting to Water and Electrical SupplyDisconnecting the Dishwasher
1. Run water at the faucet until it is hot. Turn the water off.1. Turn the hot water off. (This can be done after the last rinse.)
2. Pull the hoses out of their storage compartment on the back 2. Press the red button on the connector to release the water
of the dishwasher.pressure.
NOTE: Make sure the hoses are not kinked or twisted. Kinked
hoses reduce washing performance.
3. Pull down on the locking collar while lifting the hose 1. Faucet adapter
connector onto the faucet adapter.2. Locking collar
3. Red button
4. Hose connector
3. Lift slightly on the hose connector while pulling down the
locking collar. Pull down on the connector.
4. Empty any remaining water from the connector by turning the
connector upside-down.
5. Unplug the power supply cord and return it to the storage
compartment.
1. Faucet adapter6. Return the hoses to the storage compartment.
2. Locking collar
3. Hose connector
4. When the connector snaps into place, release the locking DISHWASHER LOADING
collar.
5. Turn the hot water on slowly until it is all the way on.
6. Plug into a grounded 3 prong outlet.Loading Suggestions
Remove leftover food, bones, toothpicks and other hard
Using the Faucetitems from the dishes. It is not necessary to rinse the dishes
before putting them into the dishwasher. The wash module
You can draw water from the faucet while the dishwasher is removes food particles from the water. The module contains a
connected. chopping device which will reduce the size of food items.
NOTE: Do not draw water while the dishwasher is filling or while NOTE: If hard items such as fruit seeds, nuts, and egg shells
water is being pumped out. (This helps prevent a low fill when enter the wash module, you might hear chopping, grinding,
dishwasher is filling or mixing drain water with fresh water when crunching, or buzzing sounds. These sounds are normal
dishwasher is draining.)when hard items enter the module. Do not let metallic items
Press the red button on the hose connector to draw water from (such as pot handle screws) get into the wash module.
the faucet. (The faucet is set on hot. Adjust the faucet for the Damage can occur.
water temperature you want.)
It is important for the water spray to reach all soiled surfaces.
Load dishes so they are not stacked or overlapping, if
possible. For best drying, water must be able to drain from all
surfaces.
Make sure pot lids and handles, pizza pans, cookie sheets,
etc., do not interfere with the spray arm rotation.
NOTE: Turn the hot water back on after you draw water from the
faucet. Turn off the cold water.Run a rinse cycle to keep dishes moist if you do not plan to
wash them soon. Foods such as eggs, rice, pasta, spinach,
and cooked cereals may be hard to remove if they are left to
dry over a period of time.
Quiet operating tips
To avoid thumping/clattering noises during operation:
Make sure lightweight load items are secured in the racks.
Make sure pot lids and handles, pizza pans, cookie sheets,
etc., do not touch interior walls or interfere with the rotation of
the spray arm.
Load dishes so they do not touch one another.
NOTE: For built-in models, keep sink drain plugs closed during
dishwasher operation to prevent noise transfer through drains.
9 |
ACEC
