4. When the connector snaps into place, release the locking NOTE: If hard items such as fruit seeds, nuts, and egg shells
collar.enter the wash module, you might hear chopping, grinding,
5. Turn the hot water on slowly until it is all the way on. crunching, or buzzing sounds. These sounds are normal
when hard items enter the module. Do not let metallic items
6. Plug into a grounded 3 prong outlet.(such as pot handle screws) get into the wash module.
Damage can occur.
Using the FaucetIt is important for the water spray to reach all soiled surfaces.
You can draw water from the faucet while the dishwasher is Load dishes so they are not stacked or overlapping if
connected. possible. For best drying, water must be able to drain from all
NOTE: Do not draw water while the dishwasher is filling or while surfaces.
water is being pumped out. (This helps prevent a low fill when
dishwasher is filling or mixing drain water with fresh water when Make sure pot lids and handles, pizza pans, cookie sheets,
etc., do not interfere with the spray arm rotation.
dishwasher is draining.)
Press the red button on the hose connector to draw water from Run a rinse cycle to keep dishes moist if you do not plan to
the faucet. (The faucet is set on hot. Adjust the faucet for the wash them soon. Foods like eggs, rice, pasta, spinach, and
water temperature you want.)cooked cereals may be hard to remove if they are left to dry
over a period of time.
Quiet operating tips
To avoid thumping/clattering noises during operation:
Make sure lightweight load items are secured in the racks.
Make sure pot lids and handles, pizza pans, cookie sheets,
NOTE: Turn the hot water back on after you draw water from the etc., do not touch interior walls or interfere with the rotation of
faucet. Turn off the cold water.the spray arm.
Load dishes so they do not touch one another.
NOTE: For built-in models, keep sink drain plugs closed during
Disconnecting the Dishwasherdishwasher operation to prevent noise transfer through drains.
1. Turn the hot water off. (This can be done after the last rinse.)
2. Press the red button on the connector to release the water
pressure.Loading the Top Rack
The top rack is designed for cups, glasses, and smaller items.
(See recommended loading patterns shown.)
NOTE: The features on your dishwasher rack may vary from the
drawings shown.
1. Faucet adapter
2. Locking collar
3. Red button
4. Hose connector
3. Lift slightly on the hose connector while pulling down the
locking collar. Pull down on the connector.
4. Empty any remaining water from the connector by turning the Cup and glass load
connector upside-down.
5. Unplug the power supply cord and return it to the storage
compartment.
6. Return the hoses to the storage compartment.
DISHWASHER LOADING
Loading Suggestions
Remove leftover food, bones, toothpicks and other hard
items from the dishes. It is not necessary to rinse the dishes
before putting them into the dishwasher. The wash module
removes food particles from the water. The module contains a Mixed load
chopping device which will reduce the size of food items.
Place items so open ends face down for cleaning and
draining.
9 |
ACEC
