POWER CLEAN* Washing System
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent
against soiled surfaces of dishes. When a program is started, the dishwasher fills with
water to about the level of the heating element. This water is pumped through the rotating
spray arms, through the POWER CLEAN Module which removes food particles, and back
through the rotating spray arms. Soiled water is pumped out and replaced with clean
water during a program -the number of times depends on the program being used.
The POWER CLEAN* Module removes food
particles from the water, stores them, then
washes them down the drain.
Load dishes so soiled surfaces face pow.
erful spray from rotating arms.
Step-saving preparation for washing
It Is not necessary to rinse dishes before might hear chopping, grinding, crunching or
putting them into the dlshwasher. Just remove buzzing sounds. Those sounds are normal when
large pieces, bones, and other hard items. The hard items enter the module. DO NOT LET
POWER CLEAN* Module will remove food parti- METALLIC ITEMS (I.E. POT HANDLE SCREWS)
cles from the water. It contains a chopping de- GET INTO THE POWER CLEAN* MODULE. THIS
vice which will reduce the size of food items. COULD RESULT IN DAMAGE TO THE POWER
If hard items such as fruit seeds, nuts and egg CLEAN* MODULE.
shells enter the POWER CLEAN? Module, You
Hot water is a must
Hot water dissolves and activates the dish- the temperature is too low, have a qualified
washing detergent. Hot water dissolves grease person raise the water heater thermostat
on dishes and helps dry glasses spot-free. Make setting.
certain loads are washed in hot water (at least
2. Use HI-TEMP WASHING Option. If water heating
140°F - 60°C). Two ways to have a reliable hot
is needed, a thermostat will delay the cycle
water supply...
until temperature reaches 145°F (63°C). If
1. Maintain 140°F water supply at central water water is hot enough, the cycle will proceed
heater. To check water temperature, turn on with no delay. This lets You turn down your
hot water faucet nearest the dishwasher. Let water heater, if You choose, without cutting
water run until it is as hot as possible, then back on hot water needed for good dish-
check with a candy or meat thermometer. If washing.
Quiet operating tips
To avoid thumping and clattering noises during or interfere with either of the spray arms
operation: rotation.
l Makesure lightweight load items aresecured l Load dishes so they don?t touch one another.
in the rack. NOTE; Keep slnk dmin plugs Inserted durlng
l Make sure pot lids and handles, pizza pans, dlshwasher opemtlon to prevent noise tmns-
cookie sheets, etc. do not touch interior walls fer through dmlns.
4
?Tmk. |
ACEC
