DELAY Pad Changing or cancelling a program
After a program has started, to cancel:
l Touch CANCEL pad once. The dishwasher will
automatically drain for 2 minutes, then shut off.
of this pad adds another hour of delay to the digi- OR
tal display., After 9 hours, touching the DELAY pad l Touch CANCEL pad twice. The display will clear
will change the display back to 1 hour. The DELAY and the dishwasher will immediately shut off.
HOURS indicator will show on the display.
To restart the dishwasher
To start the dishwasher during the delay, touch
l Check detergent dispensers to make sure they cancel to cancel the existing program; select de-
are filled properly for the new program.
sired program, then touch START. The dishwasher
l Touch START to run the dishwasher in the Program will start immediately.
Memory.
CANCEL Pad OR
l Select desired program and options, then touch
The CANCEL pad allows you to cancel a START.
program or to clear the display. If the
III dishwasher is washing, it will go into a 2
minUte drain automatically before shutting off. If
the dishwasher had not been started, it will clear
the display.
Electronic display and status indicators
The electronic display shows... Status indicators let you know what your dish-
washer is doing during a program.
l The number of minutes remaining in a program
(60,59,58 minutes, etc.) represents the WASHING, WASHING shows on the display during the wash
RINSING and HEAT DRY times. The program time portion of the program. The indicator goes off
remains the same while the water is heating. when the last wash is completed.
RINSING shows on the display during the two final
rinses before drying.
DRYING shows on the display during the dry por-
tion of the program with the HEAT DRY option.
l The number of delay hours selected (1,2,...,9).
CLEAN shows on the display when the pro-
gram is complete or immediately after the last
The dlsplay also points out operating problems:
rinse when AIR DRY is selected. Opening the door
or touching CANCEL clears the CLEAN indicator.
l ?PF? shows on the display whenever there has
been a power interruption or failure.
HEAT WATER shows on the display whenever the
water is being heated in the POTS & PANS program
or when HI TEMP option has been selected.
Whenever the dishwasher is heating water, the
digital display will show the water temperature.
When the water reaches the proper temperature,
l ?E4, E2, El or EO? show whenever there has been a the display will go back to showing the remaining
control panel malfunction. program time. NOTE: The program time remains
Touch CANCEL pad to clear display. The dish- the same while the water is heating.
washer may drain before shutting off. If the dish- DOOR OPEN flashes on the display when the door
washer display will not clear or continues to is unlatched during dishwasher programming or
show a code at the end of each cycle, call your
operation. A tone will also beep twice every 3 min-
TECH-CARE@ service technician. (See page 18.) utes for up to 2 hours.
11 |
ACEC
