PROBLEM CAUSE SOLUTION
Spotth Incorrect amount Follow recommendations on page 10 for
and fiimlng of detergent amount. Heavy soil and/or hard water
(continued) generally require extra detergent.
Use of ineffective Use fresh detergent. Store detergent tightly-
detergents closed in a cool, dry place. Discard lumpy
detergent.
Insufficient fill due to Home water pressure should be 20 to 120
bw water pressure psi for proper dishwasher fill. A booster
pump on the water supply may be neces-
sary if pressure is too low.
Cycle takes Water temperature If needed, turn home water heater up to
extremely is too bw ensure water entering dishwasher is 120°F
long time (49°C) minimum. See ?To check water
temperature? on page 19.
Dishwasher is not Undercounter dishwashers require ad-
installed properly equate enclosure for proper operation. See
Installation Instructions for complete
information.
Dishes do not Dishes do not drain Dishes must have proper water drainage.
dry completely properly Do not overload. Follow instructions for
loading dishwasher on pages 6-9. Use a
liquid rinse agent to speed draining.
Plastics Some plastics, due to material, may
need to be towel dried.
Silica film Water chemical It may not be possible to prevent problem,
or etching reaction with certain except by hand-washing. To slow this
(silica film is a types of glassware - process, use a minimum amount of deter-
white iridescent usually caused by gent but not less than one tablespoon per
deposit; etching some combination of load. Use a liquid rinse agent and
is a cloudy film) soft or softened water, underload the dishwasher to allow thorough
alkaline washing rinsing. Silica film and etching are perma-
solutions, insufficient nent and can not be removed. Use the AIR
rinsing, over-loading DRY option.
the dishwasher, and
heat of drying.
Black or gray Aluminum items Load aluminum items so that they will not
marks on dishes touching dishes rub against dishes during washing. Do not
wash throw-away aluminum items in the
dishwasher because they may break down
and cause marking. Remove aluminum
markings by using a mild abrasive cleanser.
White spots on Seasoning removed by Reseason cookware after dishwasher
cookware with dishwasher detergents washing.
non-stick finish
continued on next page
21 |
ACEC
