HOW TO USE THE DISHWASHER
Open the door and turn on the water tap.
1
1. Press theI but ton (ON) to switch on the
appliance. One of the programme indicator
lamps will illuminate.
2. Press the programme selector butt on 2
until the corresponding indicator lamp
illuminates.
If required, select any additional funct.ions
3. Press theStar buttotn to start the selected
wash programme. The Star indticator lamp
3
will illuminate. Once set, the programmed
data cannot be altered by pressing the
buttons or programme selector button. Close
the door.
Note: Once the Start button has been
pressed, the dishwasher memorises all the
programmes selected. The selected
programmes are also saved in the event of
power failure.4
4. To change the programme selected, open
the doo (beware of hot steam !) rand press
the Star buttton for about 5 seconds until the
Star indticator lamp switches off. Select a
new programme using thprogramme e
selector button, press the Star buttton, and
close the door.5
5. At the end of the programme an acoustic
signal sounds 4 times andStar the indticator
lamp switches off.
6. Press the0 but ton (OFF) to switch off the 6
dishwasher(onl y after theEnd in dicator
lamp has switched on oStr thar indte icator
lamp has switched off.) All the indicator
lamps switch off.
Note: If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
17 |
ACEC
