INSTALLING YOUR REFRIGERATOR
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
UNPACKING YOUR REFRIGERATOR
Removing packaging materials Cleaninp before use
Remove tape and any labels from your refrigerator After you remove all of the packaging materials,
before using (except the model and serial clean your refrigerator before using it if
number label). needed. See the cleaning instructions
on page 29 for more information.
To remove any remaining tape or glue, rub the
area briskly with your thumb. Do not use sharp
instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners. These products can damage the
surface of your refrigerator. For more information,
see ?Important Safety Instructions? on page 3.
NOTE: Do not remove any permanent instruction
labels inside your refrigerator, or the Tech Sheet
that is fastened under the front.
SPACE REQUIREMENTS
To ensure proper ventilation for your refrigerator,
allow for a M-inch (1.25 cm) space on each side
and at the top. For models that have ice and water
dispensers, make sure you leave some extra space
at the back to allow for the water line connections.
X-inch
minimum at
top and sides
i
71 -
7 |
ACEC
