To turn the ice maker on:
The on/off switch for the ice maker is a wire shut-off arm located
Utility or Egg Bin
on the side of the ice maker. To turn the ice maker on, simply
(on some models - Accessory)lower the wire shut-off arm.
Depending on your model, you may have a one piece utility bin or NOTE: The ice maker will not make ice until the freezer is cold
a three piece egg bin. To use the three piece egg bin, remove the enough. Allow 24 hours to produce the first batch of ice. Discard
cover and place the eggs in the egg tray. Replace cover and store the first three batches of ice produced.
on an interior refrigerator shelf. If you prefer, you can remove the
To turn the ice maker off:
egg tray and place the entire carton of eggs in the bin. Replace
nAutomatic turn off: As ice is made, the ice cubes will fill the
the cover.
ice storage bin. The ice cubes will raise the wire shut-off arm
NOTE: Eggs should be stored in a covered container. If your
to the OFF (arm up) position.
model does not have an egg bin or covered utility bin, store
eggs in their original container on an interior shelf.nManual turn off: Lift the wire shut-off arm to the OFF (arm up)
position and listen for the click to make sure the ice maker
will not continue to operate.
nTo increase ice production rate: Maximum Ice Production (on
some models): In maximum ice production, the ice maker
should produce approximately 10 to 14 batches of ice in a
24-hour period. If your refrigerator has the maximum ice
production feature, push the switch to MAX.
nNormal Ice Production: In normal ice production mode, the
ice maker should produce approximately 7 to 9 batches of ice
in a 24-hour period. If ice is not being made fast enough, turn
Wine or Can/Bottle Rack
the Freezer Control toward a higher (colder) number in half
(on some models - Accessory)number steps. (For example, if the control is at 3, move it to
between 3 and 4.) Wait 24 hours and, if necessary, gradually
To remove and replace the wine rack (left) or can/bottle rack
turn the Freezer Control to the highest setting, waiting 24
(right):
hours between each increase.
1. Remove the rack by pulling it straight out from the shelf.
Style 1 - Ice Storage Bin
2. Replace the rack by sliding it in between the shelf and the
wall of the refrigerator.To remove and replace the ice bin:
1. Pull the covering panel out from the bottom and then slide it
back toward the rear.
2. Lift the wire shut-off arm so it clicks into the OFF (up)
position. Ice can still be dispensed, but no more can be
made.
FREEZER FEATURES
3. Lift up the front of the storage bin and pull it out.
Your model may have some or all of these features. Features that
can be purchased separately as product accessories are labeled
with the word ?Accessory.? Not all accessories will fit all models.
If you are interested in purchasing one of the accessories, please
call the toll-free number on the cover or in the ?Assistance or
Service? section.
Ice Maker and Storage Bin/Bucket
(on some models - Accessory)
Style 1 - Normal and Maximum Ice Maker 4. Replace the bin by pushing it in all the way or the dispenser
will not work. Push the wire shut-off arm down to the ON
position to restart ice production. Make sure the door is
MAXclosed tightly.
Style 2 - Ice Maker
NORMAL
16 |
ACEC
