To demonstrate or Test the Display, touch and hold the RESET/TEST Pad unttl you hear two beeps.
The Performance Control Package will show in the following order:
1. 5 seconds 2. 5 seconds 3. 5 seconds; 4 beeps
All steps will repeat as long as the TEST Light is on. The 4 beeps will only sound at the end
of the first scan.
Touch the RESET/TEST Pad to return the Display to operation monitoring. A single beep will be heard.
Reading the SYSTEMS SENTINEL@ II Performance Control Package...
Each symbol on the Check Point Display has a meaning. When more than one symbol glows, there is
more than one message. The meaning of each symbol IS still the same.
The OK Light - When the ?OK? glows, refrigerator FLASHING TOO WARM Symbol -Means the refrigera-
check points are OK. The scanning lights show that tor and/or freezer were too warm, but it?s OK now.
check points are being monitored. Check for possible food spoilage. To clear the sym-
bol, touch the RESET/TEST Pad.
DOOR OPEN Symbol-Glows when any door is open.
If a door is open for more than three minutes, a beep- DOOR OPEN, ALERT
rng sound starts.
To clear the symbol and to stop the beeping
sound, close the door.
TOO WARM, ALERT
TOO WARM Symbol - Means the refrigerator and/or
freezer may be too warm for safe food storage. The
TOO WARM Symbol and one or both of the cornpart
ment temperature displays will come on to show if the FLASHING TOO WARM, ALERT
refrigerator and/or freezer are TOO WARM. You will
hear a beeping sound every two minutes The ALERT Symbol comes on when the refrigerator
The TOO WARM Symbol may glow and a beeping or freezer has been warm for 6 hours or more; there
has been an open door for 4 or more hours; or the
may start as soon as you plug in the refrigerator, refrigerator or freezer has been warm for 6 or more
Otherwise, they will start about 1 % hours after the hours, but is OK now. Check for possible food
TEMPERATURE SENSOR detects warm temperatures. spollage.
Temperatures may be warm because:
9 A large amount of food is added.
l Doors are opened often (especially in warm
weather).
l The power has been off for more than a few hours.
l The control settings are incorrect.
The CHECK COIL Symbol comes on every two
To stop the beeplng, touch and hold RESET/TEST months to remind you to check for dust and lint on the
Pad until you hear two beeps. This puts the Perform- condenser coil behind the base grille [See page 13
ance Control Package in TEST After the refrigerator for cleaning instructions.)
reaches a proper and cold enough temperature,
return the Control Package to operation scanning To clear the symbol touch the RESET/TEST Pad.
by touching the RESET/TEST Pad. |
ACEC
