Allow several hours for the refrigerator to cool down and chill Style 1: Press the LOCK button to lock the dispenser. Press the
water.UNLOCK button to unlock the dispenser.
Allow 24 hours to produce the first batch of ice. Discard the Style 2: Press and hold the LOCK OUT button to lock the
first three batches of ice produced.dispenser. Press and hold the LOCK OUT button a second time to
unlock the dispenser.
The Water Dispenser
Ice Maker and Storage Bin
IMPORTANT: Dispense enough water every week to maintain a
fresh supply.
Turning the Ice Maker On/Off
To Dispense Water:
1. Press a sturdy glass against the water dispenser lever.Style 1
2. Remove the glass to stop dispensing.To turn ON the ice maker, simply lower the wire shutoff arm.
To manually turn off the ice maker, lift the wire shutoff arm to the
The Ice DispenserOFF (arm up) position and listen for the click.
NOTE: Your ice maker has an automatic shutoff. As ice is made,
The dispensing system will not operate when the freezer door is the ice cubes will fill the ice storage bin, and the ice cubes will
open. Ice dispenses from the ice maker storage bin in the freezer raise the wire shutoff arm to the OFF (arm up) position. Do not
when the dispenser lever is pressed.force the wire shutoff arm up or down.
NOTE: Some models dispense both cubed and crushed ice. Style 2
Before dispensing ice, select which type of ice you prefer.
The ON/OFF switch is located on the top right-hand side of the
For crushed ice, cubes are crushed before being dispensed. This freezer compartment.
may cause a slight delay when dispensing crushed ice. Noise
To turn on the ice maker, slide the control to the ON (left) position.
from the ice crusher is normal, and pieces of ice may vary in size.
When changing from crush to cube, a few ounces of crushed ice To manually turn off the ice maker, slide the control to the OFF
will be dispensed along with the first cubes.(right) position.
NOTE: Your ice maker has an automatic shutoff. The ice maker
To Dispense Ice:
1. Press the button to select the desired type of ice.sensors will automatically stop ice production, but the control will
remain in the ON (left) position.
2. Press a sturdy glass against the ice dispenser lever. Hold the
REMEMBER:
glass close to the dispenser opening so ice does not fall
outside of the glass. Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
IMPORTANT: You do not need to apply a lot of pressure to the
lever in order to activate the ice dispenser. Pressing hard will The quality of your ice will be only as good as the quality of the
not make the ice dispense faster or in greater quantities.water supplied to your ice maker. Avoid connecting the ice
maker to a softened water supply. Water softener chemicals
3. Remove the glass to stop dispensing.
(such as salt) can damage parts of the ice maker and lead to
poor quality ice. If a softened water supply cannot be avoided,
The Dispenser Lightmake sure the water softener is operating properly and is well
maintained.
Style 1: The dispenser light can be turned on by pressing the ON
Do not use anything sharp to break up the ice in the storage
button.
bin. This can cause damage to the ice container and the
Style 2: When you use the dispenser, the lever will automatically dispenser mechanism.
turn the light on. If you want the light to be on continuously, you
may choose either ON or NIGHT LIGHT. Do not store anything on top of or in the ice maker or storage
ON: Press the LIGHT button to turn on the dispenser light. bin.
NIGHT LIGHT: Press the LIGHT button a second time to select
Removing and Replacing Ice Storage Bin
the Night Light. The dispenser light will automatically adjust to
become brighter as the room brightens, dimmer as the room
darkens.Style 1
OFF: Press the LIGHT button a third time to turn off the dispenser 1. Pull the covering panel up from the bottom and then slide it
light.back toward the rear.
The dispenser lights are LEDs which should not need to be 2. Lift the wire shutoff arm so it clicks into the OFF (up) position.
changed. If it appears that your dispenser lights are not working, Ice can still be dispensed, but no more can be made.
be sure that the light sensor is not blocked (in Night Light mode). 3. Lift up the front of the storage bin and pull it out.
See ?Troubleshooting? for more information.
The Dispenser Lock (on some models)
Your dispenser can be turned off for easy cleaning or to prevent
unintentional dispensing by small children and pets. 4. Replace the bin by pushing it in all the way or the dispenser
NOTE: The lock feature does not shut off power to the product, to will not work. Push the wire shutoff arm down to the ON
the ice maker, or to the dispenser light. It simply deactivates the position to restart ice production. Make sure the door is
dispenser levers. The ice and water dispensers will not work.closed tightly.
7 |
ACEC
