Is the dryer located in a room with temperature below
45oF (7oC)? Lint on load
Proper operation of dryer cycles requires temperatures above
45oF (7oC).Is the lint screen clogged?
Lint screen should be cleaned before each load.
Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and
bottom of the door. Sides and front of dryer require a minimum Stains on load or drum
of 1" (2.5 cm) of airspace, and the rear of the dryer requires 5"
(12.7 cm). See the Installation Instructions.
Was dryer fabric softener properly used?
Has an air dry cycle been selected? Add dryer fabric softener sheets at the beginning of the cycle.
Select the right cycle for the types of garments being dried. Fabric softener sheets added to a partially dried load can stain
your garments.
Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.Drum stains are caused by dyes in clothing (usually blue
jeans). This will not transfer to other clothing.
Cycle time too short
Loads are wrinkled
Was the load removed from dryer at the end of the cycle?
WARNING
Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Excessive Weight Hazard
Use two or more people to move and install dryer.Odors
Failure to do so can result in back or other injury.
Have you recently been painting, staining or varnishing in
the area where your dryer is located?
Is the automatic cycle ending early? If so, ventilate the area. When the odors or fumes are gone
The load may not be contacting the sensor strips. Level the from the area, rewash and dry the clothing.
dryer.
Is the electric dryer being used for the first time?
Change the dryness level setting on Automatic Cycles. The new electric heating element may have an odor. The odor
Increasing or decreasing the dryness level will change the will be gone after the first cycle.
amount of drying time in a cycle.
8 |
ACEC
