Using your freezer
Setting the temperature control... Cooling freezer first...
1 Insert a coin in the slot of the Temperature Control to 1. Allow freezer to cool 6 to 8 hours before filling with
turn it. frozen food.
2. Turn control to Number 3. This setting is designed to 2. Let it cool overnight before adding large amount
maintain the temperature at or near 0°F ( ~ 17.8?C)
under normal operating conditions. of unfrozen food.
NOTE: When freezer is first startled the compressor will
run constantly until the cabinet is cooled. It may take
up to 6 to 8 hours or longer, depending on room tem-
perature and the number of times the freezer lid is
opened.
After the cabinet is cooled the compressor will turn
on and off as needed to keep freezer at proper
temperature.
Adjusting the temperature
The outside of your freezer may feel warm. This is
control... normal. The freezer?s design and main function is to
remove heat from packages and air space inside the
l Turn control to higher number for colder tem-
peratures. freezer. This heat is transferred to the room uir, so the
outside walls of the freezer may be warm.
l Turn to lower number for less cold temperatures.
The sliding basket...
Can be moved from srde to side or removed when
loadrng or unloadrng food below It
To remove:
Luff basket out
To replace:
Lower basket Into place
The key eject lock... To lock or unlock the freezer you must hold the
can help reduce the hazard of chrld
key in the lock while turning The lock is spring
entrapment loaded so the key cannot be left In the lock.
If the key IS lost, contact your WHIRLPOOL
--
dealer for a replacement Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
To replace:
The signal light... 1. Unplug power cord from outlet.
automatically warns of any unexpected power 2. Carefully snap out light cover and assembly with a
failure. screwdriver by inserting it under the end of metal
If the signal light is not glowing, rmmediately check edge of the light. Be careful not to chip finish on
freezer.
l for power interruption, 3. Unplug burned out signal light and replace with a
l for an unplugged power cord, new one. Signal light can be ordered from your
l for a burned out signal light.
WHIRLPOOL dealer.
4. Then, snap light assembly into place.
5. Plug power cord into outlet.
Slgnoi light cover
I |
ACEC
