Plug It In... 3.prong groundlng
type wall receptacle
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Recommended Groundlng Method
Using Cooling Freezer First.. .
l Allow freezer to cool 6 to 8 hours before filling
your
with frozen food.
freezer l Let it cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
Setting the Cold Control...
may take up to 6 to 8 hours or longer, depending
1. Insert a coin in the slot of the Cold Control to on room temperature and the number of times
turn it. the freezer lid is opened.
2. Turn control to Number 3. This setting will main- After the cabinet is cooled the compressor will
tain zero zone temperatures under normal op- turn on and off as needed to keep freezer at
erating conditions. proper temperature.
The outside of your freezer may feel warm. This
Adjusting Cold Control.. .
is normal. The freezer?s design and main function
l Turn control to higher number for colder
is to remove heat from packages and air space
temperatures. inside the freezer. This heat is transferred to the
l Turn to lower number for less cold temperatures. room air so the walls of the freezer may be warm.
Exterior Signal light... If the signal light is not glowing, immediately
check:
automatically warns of any unexpected power
0 for power interruption,
failure.
l the power plug; it may be disconnected from
the Outlet,
l the warning light; it may be burned out.
To replace burned out slgnal Ilght:
1. Unplug power cord from outlet.
2. Carefully snap out light cover and assembly
with a screwdriver by inserting it under the
end of metal edge of the light. Be careful nOl
, g -Iht cover to chip finish on freezer.
Unplug burned out signal light and replace
with a new one. Signal light can be ordered
from your Whirlpool dealer.
Then, snap light assembly into place.
Plug cord into outlet.
Ke
The key eject lock can help reduce the hazard
of child entrapment..
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer
for a replacement.
3 |
ACEC
