Before you plug if in
Before using your freezer, you are personally o is not near an oven, radiator or other heat
responsible for making sure that it...
source.
l is installed and leveled on a floor that will l is properly maintained.
hold the weight, and in an area suitable for
l is in a dry sheltered area.
its size and use.
l is used in an area where the room tempera-
l is connected only to the right kind of outlet, ture will not exceed llO?F, (43.3?C).
with the right electrical supply and ground-
ing. (Refer to your ?Electrical Requirements l is not run where there are explosive fumes.
and Grounding Instructions?) l is not used by children or others who may not
l is used only for jobs expected of home understand how it should be used.
freezers. l is not loaded with food before it has time to
get properly cold.
Install Properly.. . level Chest Freezer,. .
from end to end and front to back sothat the lid
will seal properly.
Check with level
Remove Sales label...
Remove the Consumer Buy Guide label before
3 inches 3 inches using the freezer. Remove any left over glue with
rubbing alcohol.
Note: DO NOT REMOVE the Care and Ser-
vice label on the inside lid. This permanent
label provides immediate information
I. Check the strength of the floor. It should hold should it be needed. Do not remove Tech
weight of fully loaded freezer. Sheet permanently attached to inside of
service panel.
2. Allow at least 3 inches (7.5 cm) air space on
all sides of freezer and 2 inches (5 cm] at
Clean It...
back. Leave room at top for lid to open all the
way. Clean your freezer before using it. See clean-
ing instructions on page 4.
3. It should not be necessary to remove the lid
during installation. If. for any reason, the hinges Defrost Drain Cover.. .
need adjustment, see your authorized Installing Defrost Drain Cover:
WHIRLPOOL dealer.
1. Remove cover from literature package.
4. Do not cover the freezer with items such as 2. Check drawing on page one for placement
blankets, sheets, tablecloths, etc. 3. Install cover. |
ACEC
