Install properly...
Install defrost drain coveG..
1 Remove cover from literature package
2 Check drawing on front cover for placement
Ikl
3. Install cover
Allow room to open lid
2 inches at back Clean it . . .
Clean your freezer before
using It See cleaning
instructions on page 6
1 Check the strength of the floor It should hold the
weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow at least 3 Inches (7.5 cm] air space on all
sides of freezer and 2 inches (5 cm) at back. Leave
Plug it in...
room at top for lid to open all the way
4 It should not be necessary to remove the lid during 3-prong grounding
Installation. If, for any reason, the hinges need ad- type wall receptacle
n
Justment, see your authorized WHIRLPOOL dealer.
5 Do not cover the freezer with items such as Retaining Clip
blankets, sheets, tablecloths, etc.
Level chest freezer.. .
from end to end and front to back so that the IId WIII
seal properly.
Check with level
Freezer /
Power Plug
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only15 or 20 ampere fused
and properly grounded electrical supply is re-
Remove sales labels... quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
Remove the Consumer Buy Guide label and any
receptacle which cannot be turned off with a
inside labels before using the freezer
switch or pull chain. Do not use an extension
To remove any remaining glue:
cord.
1 Rub brtskly with thumb to make a ball, then
Attach retaining clip over power cord plug
remove
from literature package inside the freezer.
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent In 1 quart warm water] be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
4 |
ACEC
