Pull-out Freezer Floor
FREEZER FEATURES(on some models)
Your model may have some or all of these features. Features that To remove and replace the freezer floor:
can be purchased separately as product accessories are labeled 1. Lift both back ?fences? up and out.
with the word ?Accessory.? Not all accessories will fit all models.
If you are interested in purchasing one of the accessories, please 2. Remove the freezer floor by pulling it out about 1 in.
call the toll-free number on the cover or in the ?Assistance or (2.5 cm) with one hand around the air tower section (center
Service? section.back) and one hand at center front.
3. Lift up floor at rear until hooks release from cabinet and pull
the floor out the rest of the way.
Freezer Shelf 4. Replace the freezer floor by sliding the floor straight in until
(on some models)the hooks drop into place at rear of cabinet.
5. Replace ?fences? by aligning pins with socket in the floor, and
To remove and replace the shelf:pushing down until they snap into place.
1. Remove the shelf by lifting the entire shelf slightly and move it
all the way to one side. Tilt the other side up and out of the
shelf supports.
2. Replace the shelf by inserting one end all the way into the
center of the shelf supports. Then, lower the other end of the
shelf and insert it into the shelf supports.
NOTE: The shelf should lower slightly and lock into place. If the
shelf does not appear stable, make sure both ends of the shelf
are inserted into the shelf supports.
DOOR FEATURES
Your model may have some or all of these features. Features that
can be purchased separately as product accessories are labeled
with the word ?Accessory.? Not all accessories will fit all models.
If you are interested in purchasing one of the accessories, please
call the toll-free number on the cover or in the ?Assistance or
Frozen Food Storage GuideService? section.
Storage times will vary according to the quality and type of food,
the type of packaging or wrap used (should be airtight and Door Rails
moisture-proof), and the storage temperature. Seal the package
or container securely to prevent taste and odor transfer The door rails may be removed for easier cleaning.
throughout the product. Ice crystals inside a sealed package are
normal. Snap-on Door Rails
Put no more unfrozen food into the freezer than will freeze within
24 hours (no more than 2 to 3 lbs. of food per cubic foot [907-To remove and replace the rails:
1,350 g per L] of freezer space). Leave enough space in the 1. Remove the rails by pushing in slightly on the front of the
freezer for air to circulate around packages. The freezer door bracket while pulling out on the inside tab. Repeat these
must close tightly. For more information on preparing food for steps for the other end of the rail.
freezing, check a freezer guide or reliable cookbook.2. Replace the rails by aligning the ends of the brackets with the
buttons on the sides of the door liner. Firmly snap bracket
and rail assembly onto the tabs above the shelf as shown.
Adjustable Half-width Freezer Shelf
(on some models)
To remove and replace the shelf:
1. Remove the shelf by lifting the shelf up and pulling
straight out.
2. Replace the shelf over the supports and lower it into place.Drop-in Door Rails
To remove and replace the rails:
1. Remove the rails by pulling straight up on each end of the rail.
2. Replace the rails by sliding the shelf rail into the slots on the
door and pushing the rail straight down until it stops.
16 |
ACEC
