Before Using Your Refrigerator
1. Clean It
Clean your refrigerator before using it. See
cleaning instructions on page 8.
2. Plug it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
&prong grounding required. It is recommended that a separate circuit
type wall receptacle
serving only this appliance be provided. Use a re-
ceptacle which cannot be turned off with a switch
or pull chain. Do not use an extension cord.
See Electrical Requirements and Grounding
Instruction Sheet in your Literature Package.
3. Install properly
1. Allow 3 inches (7.5 cm) between overhead
cabinets and the refrigerator top.
2. Allow at least an inch (2.5 cm) between the
refrigerator condenser on the back and the wall.
3. Allow % inch (1.25 cm) on each side of the
refrigerator for ease of installation.
4. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
4. Level refrigerator-freezer
1. Keep the 4 bolts that held the refrigerator in the
shipping crate. They are the leveling legs.
2. Screw these bolts all the way into bolt holes at
the bottom corners of refrigerator.
3. Adjust each leg until the refrigerator won?t rock.
4. Slide refrigerator into place.
5. Adjust front legs to level the refrigerator.
-To raise corners, turn legs in direction shown.
-To lower corners, turn legs in direction shown.
6. Check with level. |
ACEC
