Before you plug it in
IMPORTANT
This IS the only fine print you?ll find :n this booklet l IS used only for jobs expected of home
Please read it tc be sure you use your refrigerator refrigerators
properly l IS properly maintained.
We build refrigerators to last, but we can?t con- . IS out of the weather.
trol how they are used Before using your refrlger- l IS used in an area where the room temperature
ator, you ure personally responsible for making will not fall below 55 F. (13 C).
sure that it l IS not run where there are explosive fumes
l IS installed ar:,l leveled on a floor that WIII hold l IS not used by children or others who may not
the weight, a,id in an area suitable for iis size understand how it should be used
and tise . IS not loaded with food before it has time to get
l IS connected Jnly to the right kind of outlet, with properly cold
the right electrtc supply and grounding
Pick the Right Place.
Save steps by putting your refrigerator near the sink and next to a
countertop. It should not be near a stove, radiator, water heater or
any source of heat...including direct sunlight.
You can install it flush against cabinets on each side. You should
leave 3 inches (7.5 cm] of free space above the top, and at least 1
inch (2.5 cm] between the condenser and the wall. These spaces let
the condenser ?breathe.?
Do you want it in a corner? Leave some room on the wall side if
you want the doors to open wider.
Planning to add the automatic ice maker? Will the refrigerator be
near a cold water pipe? Some people run the water line through the
floor to the basement. Others run it behind the cabinets to the pipes
under the sink.
Make Sure It?s level.
.eg
Keep the 4 bolts that hold your refrigerator in the shipping crate. They
are the levelling legs. Screw these bolts all the way into bolt holes at
the bottom corners of the refrigerator. Roll refrigerator into place.
Next, lower legs enough to lift the rollers off the floor. Adjust each leg
until the refrigerator won?t rock.
Adjust the front legs to level the refrigerator. To raise the corners, turn
legs counterclockwise; to lower the corners, turn legs clockwise.
Check with a level.
Remove the label and Clean.
Remove the Consumer Buy Guide label, tape and any inside labels
before using the refrigerator.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then remove.
OR
wall receptacle 2. Soak area with dishwashing detergent solution (1 teaspoon de-
tergent in 1 quart warm water) before removing glue as described in
step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such
as acetone, gasoline, carbon tetrachloride, etc. These can
damage the material.
DO NOT REMOVE any permanent instruction labels inside your
refrigerator.
DO NOT REMOVE the Tech Sheet fastened under the refrigerator at
the front.
Refrigerator Plug It In.
Power Cord
A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused and grounded
Recommended electrical supply is required. It is recommended that a separate circuit
Grounding Method serving only this appliance be provided.
2 Do not use an extension cord. Use a receptacle which cannot be
turned off with a switch or pull chain. |
ACEC
