Adjusting the shelves.. .
1 First, remove food from shelf.
2 Slide shelf straight out to stop.
3. Lift front.
4. Slide the rest of the way out
Replacing Shelf:
I. Fit back of shelf on top of guides with wire stops
on the bottom of guides Shelf Guide
2. Lift front, slide shelf in until it clears guide stops
Removing crispers and crisper cover.. .
Removing the Crispers:
1 Slide crrsper straight out to stop, lift front, then slide
the rest of the way out
2. Replace In the reverse order.
Removing Cover:
1 Lift front and remove the cover support
2. Lift out cover by pulling up and out.
Replacing Cover:
1. Fit back of cover into notch supports on walls of
refrigerator, then lower front into place
2 Replace cover support with the long tab towards
the front Note: If support needs adjustment, turn
Lift the Front and Pull Again.
base right to lower, or left to raise
Changing the light bulb.. .
WARNING: Before removing the light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the re-
frigerator at the main power supply.
Shock and injury can occur if elec-
1 Reach behind control console to find bulb
tricity remains connected.
2. Remove bulb.
3 Rep/ace wrth opphonce bulb on/y
Automatic ice maker.. . l You will hear water running when ice maker IS
working. You?ll hear ice fall into the bin Don?t let
these sounds bother you.
l The ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight.
l Because of new plumbing connections, the first
Raise Signal ice may be discolored or off-flavored. Discard the
Arm to Stop Ice Maker. first few batches of ice.
l If ice is not being made fast enough and more ice
Lower Signal
Arm to Start It is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, if necessary, turn
the Freezer Control toward A.
l If you remove the Ice bin, raise the signal arm to
If you have the automatic ice maker accessory or shut off the Ice maker. When you return the bin,
plan to add one later [Part No. ECKMF-831, there are a push it all the way In and lower the arm to the ON
few things you WIII want to know: posrtion.
l The ON /OFF lever is a wire srgnal arm l If cubes are stored too long, they may develop an
Down., .for making Ice automatrcally, off-flavor...llke stale water. Throw them away They
Up...toshut off the ice maker. will be replaced. Cubes in the ice bin can also
l Shake the bin occasionally to keep cubes sepa- become smaller by evaporation.
rated, and to obtain increased storage capacity. l The ice maker water supply should not be soft-
l It is normal for ice crescents to be attached by a ened water. The chemicals could damage the ice
corner. They will break apart easily. maker molds.
6 |
ACEC
