Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachioride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigercrtor at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on Page 8,
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5 cm] between the refrig-
Plug it in...
erator condenser and the wall.
3. Allow J/Z inch (1.25 cm] on each side of the re- Sprang
frigerator for ease of installation. grounding type
4. If the refrigerator is to be against a wall, you might wall receptacle
want to leave enough space so the door can be
opened wider.
j-prong
I
Level refrigerator-freezer... grounding plug
t
Use Screwdriver Leveling screw Retrigerator
to Adjust
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Lefl to Lower Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
1. To raise front, turn each screw to the right. or pull chain. See individual electrical require-
2. To lower front, turn each screw to the left ments and grounding instruction sheet in your liter-
3. Check with level. ature package.
4 |