Changing the light Bulb... Removing the Base Grille...
Before removrng the light shield for cleanrng or for l Open the door
replacing the bulb, unplug the refrigerator. Use
oookmce bulbs on/v
rllle-holdlng labs
Push in the Center;
l Lift up on the two tabs showing through the grille
l Push lightly on the top center of the light shield untrl at both ends near the top.
the notched tab unhooks from the control panel.
l Pull down on the shield until the tab clears the
control panel.
l Lrft the back hooks out of their slots.
l Replace with a 40.watt appliance bulb.
l Replace light shreld In reverse order.
Ice Cube Trays...
To remove Ice:
l Hold tray at both ends.
l Slightly twist.
l Swing the top of the grille forward.
l Lift the grille off the bottom supports.
If cubes are not used, they may shrink. The moving l Replace in reverse order.
cold air starts a slow evaporation. The longer cubes l Do not remove Tech sheet fastened behind the
are stored, the smaller they get. grille.
Sounds you may hear...
Your new refrigerator may make sounds that your old one didn?t.
Because the sounds are new to you, you might be concerned about
them. Don?t be. Most of the new sounds are normal. Hard surfaces like
the floor, walls and cabinets can make the sounds seem louder.
The following chart describes the kinds of sounds that might be new
to you, and what may be making them.
Possible Sounds: Probable Causes:
l Slight Hum, Soft Hiss: You may hear fan motors and moving air.
l Clicking or Snapping The defrost timer makes a definite click when the refrigerator stops running. It
Sounds: also makes a sound when the refrigerator starts.
l Water Sounds: When the refrigerator stops running, you may hear gurgling in the tubing for a
few minutes after it stops. You may also hear defrost water running into the
defrost water pan.
l Running Sounds: Your refrigerator has a high-efficiency compressor and motor. It will run longer
than older designs. It may even seem to run most of the time.
5 |
ACEC
