Removing and adjusting the freezer
To remove shelf:
1. Lift front slightly
2. Lift back off supports.
3. Replace in reverse order
To adjust shelf:
1. Remove shelf.
2. Remove supports by sliding upwards.
3. Replace supports on desired level.
4. Replace shelf.
Ice cube trays.. .
If cubes are not used, they may shrink. The moving To remove ice:
cold air starts a slow evapotction. The longer cubes 1. Hold tray at both ends.
are stated, the smaller they get. 2. Slightly twist.
Optional automatic ice maker.. . l Ycu will hear water running when ice maker is
working. You?ll hear ice fall into the bin. Don?t let
If you have the automatic ice maker accessory or
these sounds bother you.
plan to add one later [Part No. ECKMF-83), there are
l The ice maker will not operate until the freezer is
a few things you will want to know:
cold enough to make ice. This can take overnight.
l The ON/OFF lever is a wire signal arm. l Because of new plumbing connections, the first
Down., .for making ice automatically; ice may be discolored of off-flavored Discard the
Up...toshut off the ice maker. first few batches of ice.
l Shake the bin occasionally to keep cubes sepa-
l If ice is not being made fast enough and more ice
rated, and to obtain increased storage capacity. is needed, turn the Refrigerator Control toward a
l It is normal for ice crescents to be attached by a
higher number. Wait a day and, if necessary, turn
corner. They will break apart easily.
the Freezer Control toward A.
On l If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin.
push it all the way in and lower the arm to the ON
position.
l If cubes are stored too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.
l Good waterquality is important for good ice qUalitV
It is not recommended that the ice maker be con-
Lower Signal \ Raise Signal I netted to a softened water supply. Water softener
Arm to Start it. Arm to Stop ice Maker.
chemicals such as salt from a malfunctioning soft-
ener can damage the ice maker mold and lead to
poor quality ice. If a softened water supply cannot
be avoided, then it is important that the water soft-
ener be well maintained and operating properly. |
ACEC
