Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re-
frigerator To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
Clean it...
+ Clean your refriger-
ator before using it.
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and refrigerator top. See cleaning in
tions on page 8.
2. Allow at least an inch (2.5 cm) between the re-
frigerator condenser on the back and the wall
3. Allow Y2 inch (1.25 cm) on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
Level refrigerator-freezer.. .
Plug it in...
USE SCREWDRIVER
TO ADJUST J-PRONG GROUNDING
TYPE WALL RECEPTACLE
LEVELLING SCREW R&E
I I
.
LEFT TO LOWER REFRIGERATOR 3-PRONG
POWER CORD GROUNDING PLUG
1. To raise front, turn each screw to the right
RECOMMENDED GROUNDING METHOD
2. To lower front, turn each screw to the left.
3. Check with level. A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir-
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package. |
ACEC
