Playing Back Tapes
You can play back type I, type II, and type IV tapes withoutTo play both sides repeatedlyNReverse Mode
changing any settings.Reverse Mode works for both decks at the same time.
When it is in use, the tape automatically reverses at the end of
Playing Back a Tapea side and the unit starts playing for the other side of the tape,
and repeats the same process.
To use Reverse Mode, press
1Press EJECT (0) for the deck you want toREVERSE MODE so that the Reverse Mode
use.indicator on the display lights up likeN.
To cancel Reverse Mode, press the button
again so that the Reverse Mode indicator on the
display lights up likeN .
For Deck B
When Reverse Mode is on with cassettes in both decks
A and B
After the reverse (2) side of the tape finishes playing, the tape in theFor Deck A
2Put a cassette in with the exposed part of theother deck starts playing.
tape down.
Locating the Beginning of a Song
NMusic Scan
You can use Music Scan to locate the beginning of a song.
Music Scan searches for blank portions that usually separate
recorded songs, then plays the next song.
3Close the cassette holder gently.To find the beginning of the current song
If you put cassettes in both decks A and B, the last deckDuring play, press ! or 1 in the
you have closed is selected.opposite direction to the tape play.
The tape direction indicator of the opposite
To operate the other deck, press TAPE A/B
(or press TAPE A/B while holding SHIFT ondirection to the tape play starts flashing
the remote control).slowly.
Searching stops automatically at the beginning of the current
4Press TAPE 2 3.song, and the current song starts automatically.
The tape play starts and the tape
direction indicator (3 or 2) on theTo find the beginning of the next song
display starts flashing slowly toDuring play, press ! or 1 in the same
indicate the tape running direction.direction as the tape play.
Y Each time you press the button, theThe tape direction indicator of the same
tape direction changes.direction as the tape play starts flashing
33333 : plays the front side.slowly and quickly alternately.
22222 : plays the reverse side.Searching stops automatically at the beginning of the next
Y If no cassette is inserted, ONO TAPE� appears on thesong, and the next song starts automatically.
display.
When the tape plays to the end, the deck automaticallyMusic Scan works by detecting a 4-second long blank
stops if the Reverse Mode is off. (See OTo play both sidesbetween each song, so it will not work well in the
repeatedlyNReverse Mode.�)following cases
Y No blank at the beginning of a song.
Y Noise (often caused by much use or poor quality dubbing) which
fills the blank.
To stop playing, press 7.Y Long, very soft passages or pauses in a song.
To fast-wind to the right or to the left, press ! or 1
while the tape is not running.The use of the C-120 or thinner tape is not
The tape direction indicator (3 or 2) starts flashing quicklyrecommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
on the display.
rollers and the capstans.
To remove the cassette, press 0 EJECT for deck A or
EJECT 0 for deck B.
� 30 �
EN28-31.CA-MXDVB10,B9,A9_f3002.4.24, 9:44 AM |
ACEC
