To Replace:
Oven Light1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
(on some models)
2. Hold oven door so that the top edge of each hinge hanger is
The oven light is a standard 40-watt appliance bulb. It will come
horizontal. Insert hinge hangers into the front frame hinge
on when the oven door is open. It will not work during the Self-
slots.
Cleaning cycle (on some models). On some models, when the
3. Tilt top of door toward range. Slide hinge hangers down onto
oven door is closed, press OVEN LIGHT to turn it on or off.
front frame support pins. Make sure the hinge hangers are
Before replacing, make sure the oven and cooktop are cool and
fully seated and engaged on the support pins.
the control knobs are off.
To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
4. Insert the door stop clip with the angular surface at the top of
the frame hinge slot, then push in the bottom of the clip until
flanges are flush with the front frame.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Plug in range or reconnect power.
5. Open the door completely and remove the door removal pins.
Save door removal pins for future use.
Oven Door
6. Close the door.
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.Storage Drawer
Before Removing:The storage drawer can be removed. Before removing, make sure
1. Use a putty knife or screwdriver and insert it at the bottom drawer is cool and empty.
corner of the door stop clip.To Remove:
1. Pull the storage drawer straight back past the drawer stop
notch and the end of the side rails.
2. Pry door stop clip free and remove from front frame hinge
slot. Be certain not to scratch finish.
3. Repeat procedure for other door stop clip.
To Remove:
B
1. Open the oven door. Insert door removal pins, included with A
your range, into both hinge hangers. Do not remove the pins A.Drawer stop notch
while the door is removed from the range.
B.End of side rail
2. Lift up the back of the drawer and pull the drawer out.
To Replace:
1. Lift up the back of the drawer and place it inside the range in
its fully forward position.
2. Lift up the front of the drawer to a level position.
2. Slowly close the door until it rests against the door removal
3. Slowly push the drawer into the range until the drawer side
pins.
rails engage with the gap in the drawer glides.
3. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
4. Pull door straight up, then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove door
A
removal pins until the door is replaced on the range.
A.Engage drawer glide
17 |
ACEC
