ZANUSSI CB 340 1C Instruction Manual

If something does not work
If the appliance is not working correctly, please carry out the following checks before
contacting your local Service Force Centre.
SymptomPossible causeSolution
It is too warm in the Thermostatic control can be setSet the thermostat knob to higher
refrigerator.incornectly.position.
If products are not cold enough orPlace the products to the appropriate
placed wrongly.place.
The door does not close tightly or it is notCheck if the door closes well and the
gasket remains clean and
shut properly.undamaded.
Thermostatic control can be setSet the thermostat knob to higherIt is too warm in the
freezer.
incornectly.position.
Check if the door closes well and the
The door does not close tightly or it is not
shut properly.gasket remains clean and
undamaded.
Products in big quantity to be frozenWait some hours and then check the
were put in.
temperature again.
Products to be frozen are placed tooPlace the products in a way so that
closely to each other.
cold air could circulate among them.
Water flows at the back It is normal. During automatic defrosting
plate of the refrigerator. frost melts on the back plate.
Water flows into the The outlet of the chamber can beClean the outlet.
chamber.clogged up.
Products placed in can prevent waterReplace the products so that they do
from flowing into the collector.
not touch the back plate directly.
Water flows onto the The melting water outlet flows not intoPut the melting water outlet to the
floor.the evaporative tray above theevaporative tray.
compressor.
There are too much frost Products are not wrapped properly.Wrap the products better.
and ice.Doors are not shut properly or do notCheck if the doors close well and the
close tightly.
gaskets remain clean and
undamaded.
The thermostatic control can be setSet the thermostat knob to a position
wrongly.that gives higher temperature.
The compressor The thermostatic control is set wrongly.Set the thermostat knob to a position
operates continually.that gives higher temperature.
Doors are not shut properly or do notCheck if the doors close well and the
close tightly.gaskets remain clean and
undamaded.
Products in big quantity to be frozenWait some hours and then check the
were put in.temperature again.
Too warm food was put in.Put food at max. room temperature.
The appliance is in too warm place.Try to reduce the temperature in the
room where the appliance stands.
Plug is not connected to the mains
socket properly.The appliance does notConnect the mains plug properly.
work at all. Neither
cooling, nor lighting The fuse burnt out.Change the fuse.
works. The thermostatic control is not on.Start the appliance according to
instructions in chapter 'Putting it into
There is no voltage in the mains socket.use'.
(Try to connect another appliance into it.)
The appliance is not supported properly.The appliance is noisy.Check if the appliance stands stable
(all the four feet should be on the
floor).
11