Operating sequence
1. Check the filters9. At the end of the washing
Ensure that they are clean and properly positioned. programme
(See "Maintenance and cleaning" - Instruction At the end of the programme the dishwasher will
book - part 1)automatically stop.
The On/Off indicator light remains on until the On/Off
push button is depressed.
2. Check that there is rinse aid and
salt
(See "Instruction book" - part 1)10. Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off
push button.
3. Load the dishes Wait 15/20 minutes before opening the
dishwashers door; in this way you will avoid
Remove any scraps of food.
Pull the lower basket out and arrange the burning yourself when removing the dishes and
avoid also the damage of the nearby furniture
saucepans, plates and cutlery in it. caused by the escape of steam.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it. Empty the lower basket first and then the upper one;
this will avoid water dripping from the upper basket
Slide the baskets back into the machine. onto the dishes in the lower one.
4. Ensure that the spray arms can
When the washing programme has finished, it
rotate freely is recommended that the dishwasher is
unplugged and the water tap turned off.
5. Measure out detergent In general it is not advisable to open the door
while the machine is working; if the door is
Add the detergent into the dispenser according to opened however, a safety device ensures that
the dosage quantity given in the "Washing the machine stops.
programmes" chart.
Close the detergent dispenser lid.
6. Close the dishwasher door Important!
Care must be taken if the door is opened during
the hot phase or immediately after a
programme has finished, as steam may escape.
7. Set the programme
Turn the programme selector dial clockwise until
the letter of the programme you wish to select
corresponds with the programme marker on the
control panel.
If necessary select the temperature of the main
wash (or a half load programme) according to the
instructions in the "Washing programmes" chart
(see "Required push buttons").
8. Start the programme
Depress the On/Off push button.
The On/Off indicator light will come on and the
machine will start.
If you wish to interrupt the washing programme at
any time press this button again.
14 |
ACEC
