Operating sequence
1. Check the filters 10. At the end of the washing
Ensure they are clean and properly positioned (see programme
"Maintenance and cleaning").
The dishwasher will automatically stop and the phase
indicator light end of programme will come on.
2. Press the ON-OFF push buttonThe indicator light of the programme just ended will
The ON-OFF indicator light will come on.remain on.
The dishwasher has finished the programme only when
the end of programmeindicator light is illuminated.
3. Check that there is rinse aid
and salt If you do not wait for the end of the programme it will not
be possible to start a new programme if first you do not
The corresponding indicator lights will illuminate if refilling cancel the previous.
is necessary.(For instructions on how to cancel a programme see
point 9)
4. Load the dishes Switch off the dishwasher by pressing the ON-OFF push
button and open the door.
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, Wait a few minutes before removing the dishes; in this
way they will be cooler and drying will be improved.
plates and cutlery in it. Empty the lower basket first and then the upper one; this
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it. will avoid water dripping from the upper basket onto the
dishes in the lower one.
Slide the baskets back into the machine.
5. Ensure that the spray arms can Important!
In general it is not advisable to open the door while the
rotate freely machine is working; if the door is opened however, a
safety device ensures that the machine stops.
6. Measure out detergent Care must be taken if the door is opened during the hot
phase or immediately after a programme has finished, as
Add the required amount of detergent into the dispenser steam may escape.
according to the recommended quantity given in the
Washing programmes chart. When the washing programme has finished, it is
Close the detergent dispenser lid.recommended that the dishwasher is unplugged and the
water tap turned off.
7. Close the dishwasher door
8. Setting and starting the programme
Press the push button corresponding to the required
programme: the indicator light corresponding to the
programme illuminates and the phase indicator lights for
that programme start flashing.
The start of the programme will occur after about 6
seconds from the last pressure of a programme push
button, in this time it is possible to change programme
simply pressing the push button of another programme.
Once the programme has started the phase indicator
lights will turn off except for the phase under way.
It is possible to interrupt the programme by:
opening the door
pressing the ON-OFF (in this case all the indicator
lights turn off)
Close the door again or press the ON-OFF, the
programme will start from the point in which it was
interrupted.
9. To cancel a programme in progress
A programme in progress can be cancelled at any time.
Press for about 3 seconds the push button of the running
programme until all indicator lights are off.
Only the ON-OFF indicator light will remain on once the
programme has been cancelled.
It is now possible to select a new washing programme.
11 |
ACEC
