Operating sequence
1. Check the filters 8. Start the programme
Ensure they are clean and properly positioned Depress the On/Off pushbutton. The On/Off
(see cleaning instructions). indicator light comes on and the machine will
start.
2. Check that there is rinse
9. At the end of the
aid and salt
washing programme
At the end of the washing programme the
dishwasher stops automatically. The On/Off
3. Load the dishes indicator light remains on until the On/Off
pushbutton is depressed.
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates,10. Switch off the
saucers, glasses and cups etc. in it.
Slide the basket back into the machine. dishwasher
Switch off the dishwasher by pressing the
On/Off pushbutton.
4. Ensure that the spray
arms can rotate freely.When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.
5. Measure out detergent
In general it is not advisable to open
Add the required amount of detergent into the
dispenser according to the "Washing the door while the machine is
programmes" chart and close the lid. working. If the door is opened
however, a safety device ensures
that the machine stops.
Care must be taken if the door is
6. Close the detergent opened during the hot phase or
immediately after a programme has
dispenser lidfinished, as steam may escape.
7. Select the programme
Close the door.
Turn the programme selector dial clockwise
until the programme letter you wish to select
corresponds with the programme marker on the
control panel.
15POS04UK |
ACEC
