Operating sequence
1. Check the filters 9. At the end of the washing
Ensure they are clean and properly positioned programme
(see "Maintenance and cleaning").
At the end of the programme the
dishwasher will automatically stop.
The On/Off indicator light remains on until
2. Check that there is rinse aid the On/Off push button is depressed.
and salt
10. Switch off the dishwasher
3. Load the dishes Switch off the dishwasher by pressing the
Remo ve any scraps of food.On/Off push button and open the door.
W ait a few minutes before removing the
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.dishes;in this way they will be cooler and
the drying will be improved.
Pull the upper basket out and arrange the Empty the lower basket first and then the
plates, saucers, glasses and cups etc.in it.
upper one;this will avoid water dripping
Slide the baskets back into the machine.from the upper basket onto the dishes in the
lower one.
4. Ensure that the spray arms can
When the washing programme has
rotate freely.finished,it is recommended that the
dishwasher is unplugged and the water
tap turned off.
5. Measure out detergent
In general it is not advisable to open the
Add the required amount of detergent into the door while the machine is working;if the
dispenser according to the dosage instructions door is opened however,a safety device
from the manufacturer of your brand.ensures that the machine stops.
Close the detergent dispenser lid.
6. Close the dishwasher doorImportant!
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished,as
7. Set the programmesteam may escape.
Turn the programme selector dial clockwise until
the letter of the programme you wish to select
corresponds with the programme marker on the
control panel.
8. Start the programme
Depress the On/Off push button.
The On/Off indicator light will come on and
the machine will start.
13SEQ09en |
ACEC
