Operating sequence
1. Check the filters 8. Start the programme
Ensure they are clean and properly positioned Depress the On/Off pushbutton. The On/Off
(see cleaning instructions). indicator light comes on and the machine will
start.
2. Check that there is rinse
aid and salt9. At the end of the
washing programme
3. Load the dishes
At the end of the washing programme the
Remove any scraps of food. dishwasher stops automatically. The On/Off
Pull the lower basket out and arrange the indicator light remains on until the On/Off
saucepans, plates and cutlery in it. pushbutton is depressed.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
10. Switch off the
Slide the basket back into the machine.
dishwasher
4. Ensure that the spray
Open the door and switch off the dishwasher by
pressing the On/Off pushbutton.
arms can rotate freely.
5. Measure out detergent When the wash programme has
finished, it is recommended that the
Add the required amount of detergent into the dishwasher is unplugged and the
dispenser according to the "Washing water tap turned off.
programmes" chart and close the lid.
In general it is not advisable to open
6. Close the detergent the door while the machine is
working. If the door is opened
dispenser lidhowever, a safety device ensures
that the machine stops.
Care must be taken if the door is
7. Select the programmeopened during the hot phase or
Close the door.immediately after a programme has
finished, as steam may escape.
Push the programme selector dial in to make it
pop out. Then turn the programme selector dial
clockwise until the letter of the programme you
wish to select corresponds with the programme
marker on the control panel.
Select the temperature according to the
instructions in the "Washing programmes" chart
(see "Required pushbuttons").
If no button is depressed, the water will be
heated up to 65!C.
17POS08UK |
ACEC
