Starting a washing programme
1. Check that the baskets have been To interrupt a washing programme in
loaded correctly and that the spray progress
a)Open the dishwasher door; the programme will stop.
arms can rotate freely
Close the door; the programme will start from the
point at which it was interrupted.
b)Press the On/Off button (in this case all the indicator
2. Turn on the water tap
lights turn off). Press the On/Off button again; the
programme will start from the point at which it was
interrupted.
3. Close the dishwasher door
To cancel a washing programme in
progress
4. Press the On/Off buttonTo cancel a washing programme in progress, press
simultaneously the function buttons 2 and 3 until all the
The On/Off indicator light will come on.indicator lights will turn off (except for the On/Off indicator
light and eventually the rinse aid and salt indicator lights)
indicating that the running programme has been cancelled.
5. Setting and starting the programme (If a new washing programme will be selected, check that
a)Press the button corresponding to the required there is detergent in the detergent dispenser).
programme (see "Washing programmes" chart).
The indicator light corresponding to the programme
and the phase indicator lights foreseen for that 7. Cancelling the "delay start" in
programme will start blinking. progress
After about 3 seconds from the last pressure of a button
the programme starts automatically.It is possible to cancel a countdown in progress or before
it starts, simply pressing the delay start button until the
Once the programme has started the phase indicator
lights will turn off except for the phase under way. indicator lights corresponding to the delay start hours (3h,
6h or 9h) turn off.
b)If you want to set the "delay start" of a washing In this case the selected washing programme will start
programme:automatically after a 3 seconds.
Set the delay start before selecting a washing
programme.
Press the "delay start" button until the indicator light 8 . End of the washing programme
corresponding to the chosen hours flashes (3h, 6h or The dishwasher will automatically stop and the End of
9h)
Press the button corresponding to the required programme phase indicator light will illuminate.
The indicator light of the programme just ended will
programme (see "Washing programmes" chart). remain on.
After about 3 seconds from the last pressure of a button
the countdown starts automatically.Switch off the dishwasher by pressing the On/Off button,
the On/Off indicator light turns off.
The countdown will decrease with steps of 3 hours.
The opening of the door will not modify or interrupt the Open the door and wait a few minutes before removing
countdown. the dishes; in this way they will be cooler and the drying
will be improved.
Once the delay start has elapsed the programme will
start automatically.
Note:it is possible to select a washing programme and 9. Unloading the dishwasher
the "delay start" also with the door slightly opened.Hot dishes are sensitive to knocks. The dishes should
In this case the start of the programme or of the
countdown will occur after the closure of the door.therefore be allowed to cool down before removing from
the appliance.
a)Press On/Off button.Empty the lower basket first and then the upper one; this
b)Select a washing programme and if required the will avoid water dripping from the upper basket onto the
"delay start".dishes in the lower one.
c)Close the door.Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
The programme or the countdown will start automatically cooler than the dishes.
after about 3 seconds from the closure of the door.
When the washing programme has finished, it is
6. To interrupt or cancel a washing recommended that the dishwasher is unplugged and the
water tap turned off.
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if itOs absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
14 |
ACEC
