MAINTENANCE AND CLEANING
Before any maintenance or cleaning work is carriedChanging the light bulb
out, DISCONNECT the appliance from the ELEC-
TRICITY supply.
Should the interior light fail to work, first switch off
the appliance and disconnect from the electricity
Warning
supply, then replace the bulb as follows:
This appliance contains hydrocarbons in its
1.Unscrew the light cover and then pull it outward
cooling unit maintenance and recharging
by pressing as shown in the figure. Unscrew the
must therefore only be carried out by
bulb and replace it with a new 15 watt bulb (avail-
authorised technicians.
able from your nearest Electrolux Service Force
centre).
Internal cleaning
Clean the inside and accessories with warm water
and bicarbonate of soda (5ml to 0.5 litre of water).
Rinse and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE POW-
DERS, HIGHLY PERFUMED CLEANING PROD-
UCTS OR WAX POLISHES, TO CLEAN THE INTE-
RIOR AS THESE WILL DAMAGE THE SURFACE
AND LEAVE A STRONG SMELL.
Clean the drain hole of the water trough at regularD411
intervals and make sure that the drain hole is never
obstructed, so that the defrost water may flow freely2.Replace the light cover by sliding it into its original.
position and replacing the screw.
External cleaning
When the appliance is not in use
Wash the outer cabinet door with warm soapy water.
When the appliance is not in use for long periods,
Importantdisconnect from the electricity supply, empty all
Do not use abrasive products.foods and clean the appliance, leaving the door ajar
to prevent unpleasant smells.
Periodic cleaning
The appliance is equipped with a ventilation grid.
Keep clean to guarantee good ventilation and good
working order of the appliance.
An accumulation of dust will affect the performance
of the appliance and cause excessive electricity con-
sumption.
The structure of the appliance permits to clean the
rear zone close to the wall, using a vacuum cleaner.321
1.Remove the plinth (1), then the ventilation grid (2);
2.Carefully pull the air deflector out (3), checking
that there is no water left from the defrosting.
S.I.013
9 |
ACEC
