Installation
Transit security barsHydraulic connection
Before starting the machine up, the transport
There should be a COLD WATER tap near the
security bars must be removed as follows:
washing machine with a screwing on connection
You are advised to keep all the transport security
bars in case the appliance has to be transportedpipe of 3/4 gas for the water supply, a sink, a wash
basin or a drainage system in the wall.
again.
Previously check if:
1. Unscrew and remove
N it is not a hot water tap.
the three rear screws
by means of a key.N the running water is clean. If not, run off a
ENGLISH
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Have the permanent drainage system in the wall
checked by a plumber.
P0287
A) Carefully screw the
pipe to the tap taking
care not to damage the
2. Lean the appliance
screwdrive and fix the
back on the rear and
nut well on to the end in
fit one of the
order to avoid leaking.
polystyrene angles
between the appliance
and the floor.
Make sure the hoses
P0018
are not squashed.
B) If necessary turn the
hose adequately by
3. Carefully remove the
unscrewing the nut at the
plastic bags on the
rear of the appliance.
right and the left,
pulling them to the
C) Now tighten the nut
1centre of the appliance
anew to avoid leaks.
2
(Open the tap and asure
P0021that it does not leak and
AL009close it again.)
D) Place the discharging
hose in a washbasin or
sink with the aid of the
bent piece delivered
separately. The bent
piece has to be entered
into the tubeOs mouth in
order to assure the
support. Aforesaid piece
P0001P0002
allows the hose to be
fixed to the wall by means
4. Place the machine in an upright position and
of an opening on the
remove the three plastic bolts.
upper part and that way
5. Plug the 3 holes with the plastic plugs which youthe hose does not move
can find in the envelope containing the instructionand its falling is avoided.
booklet.
27 |
ACEC
