Editing a PatchEditing a Patch
The patches of the 505 II can be freely edited by changing the effect
parameter settings. Try editing the currently selected patch to create
your own sound.Change the parameter value
Use the [+]/[-] keys.
Holding down one of these keys will
Select the effect continuously change the value. Additionally
pressing the opposite key will cause a faster
parameter
change. Pressing both keys simultaneously
Use the [PLAY/EDIT] selector to skips to the first value of the next effect type
EditingaPatchselect the effect you want to in the same effect module.EditingaPatch
change.
The value of the currently Parameter
value
selected parameter is
Changing the module
shown on the display.
(When the 505 II is in edit on/off condition
mode, a dot (.) is shown in
40Press both [ ]/[ ] foot switches
the bottom right section of
together.
the display.)
Lit
This is possible only if the basic parameter of
Modules and parameters that can be that module (marked with an asterisk in the
selected with the [PLAY/EDIT] selectorillustration ) has been selected.
(1) Patch level When an effect module has been
(2) Basic parameters of COMP module (*) NOTEswitched off, the extended parameter
(3) Basic parameters of DIST module (*) of that module is not shown.
(4) Extended parameters of DIST module
(5) Basic parameters of EQ module (*)
(6) Extended parameters of EQ module
(5)
Terminate the edit mode
(6)
(4)(7) Basic parameters
of ZNR/AMP module (*) To terminate the edit mode and return to the
(3)(7)
(8) Basic parameters play mode, set the [PLAY/EDIT] selector to the
(2)(8)of MOD module (*) "PLAY" position.
(9) Basic parameters
(9)Unless you store the edited patch in memory, the
(1)of DLY/REV module (*) NOTE
settings you made will be lost when you select a
(10)(10) Extended parameters
of DLY/REV module different patch after returning to the play mode. Do
not forget to store an edited patch that you wish to
keep, as described on page 14.
12ZOOM 505 II GUITARZOOM 505 II GUITAR13 |