Restoring the Factory Defaults Adjusting the Expression Pedal
The 606 comes with 42 recommended patches (factory defaultThe expression pedal of the 606 is adjusted for optimum operation at
patches). Even if you overwrite any of these patches, you can restorethe factory, but sometimes, readjustment may be necessary. If the
the original contents of the patch at any time. action of the pedal seems to be insufficient, or if a large change occurs
There are two ways of restoring factory defaults. "All Initialize" returnseven if the pedal is only lightly pushed, adjust the pedal as follows.
the entire set of patches to the original condition. "Factory Recall"
restores a specific patch to the original condition.
1.While holding down the PEDAL ASSIGN key,
turn the unit on. dn
1.While holding down the STORE key, turn the unit on. The indication "dn" flashes on the display.
The indication "AL" flashes on the display.
2.With the expression pedal fully raised, press the STORE
To perform All Initialize
key.
2.Press the STORE key once more. The display indication changes to "UP".
All patch settings are returned to the factory default condition, and
the unit switches to play mode. To cancel All Initialize, press the
VALUE [-] key. UP
Pedal fully raised
RestoringtheFactoryDefaults
NOTEAll user-created patches will be lost when performing All Initialize.
Use this function with care. 3.Push the expression pedal fully down and then lift yourAdjustingtheExpressionPedal
foot off the pedal.
To perform Factory Recall When you release your foot, the pedal goes back a little.
2.Use the [W] / [Q] foot switches to select the
patch you want to return to the original
condition. Push strongly,
so that pedal When foot is lifted,
The specified bank and patch number flashes on the display. touches here pedal returns slightly
During Factory Recall, the VALUE [+] / [-] keys cannot be used to4.Press the STORE key.
switch the bank only. The adjustment is completed, and the unit returns to the play mode.
3.Press the STORE key once more.
The point where the STORE key is pressed in step 3 determines the
The settings of the specified patch are returned to the factory defaultmodule on/off switching point. If you want the pedal to perform
condition. on/off switching with a lighter touch, push the key at a somewhat
If desired, repeat steps 2 and 3 to restore other patches. To terminatehigher position of the pedal.
the Factory Recall operation, press the VALUE [-] key. The unit will
switch to the play mode at this point.
22ZOOM 606 GUITARZOOM 606 GUITAR23 |
ACEC
