ZOOM B2 Instruction Manual

EB2.fm 26 Z
8
?
?
?
??
?e
?
?xýI
Uxý9=
?p
?
? 
Effect Types and Parameters
MSMSMONO SYN (Mono Synth)
This is a monophonic (single-note) bass synthesizer that detects the input signal pitch.
s1 s5, p1
CABINEToF, 1 3VARI DECAY0 98, 1.0
p5, m1 m5
Selects the waveform type and sound
Numeric settings select different cabinet variation. "s" produces a sawtooth wave,
Adjusts the rate of sound change.
types."p" produces a square wave, and "m"
uses PWM (pulse width modulation).
ZNR/MIX
ZNR/MIX module
This module serves for reducing noise during playing pauses. The module also is used to
control the mixing balance of original sound and effect sound for the DRIVE/SYNTH
module, and the signal level after the module. The ZNR/MIX module cannot be turned off
with the foot switch. To disable ZNR, set the effect parameter value to "oF".
NRnrZNR (ZOOM Noise Reduction)
This is ZOOM's original noise reduction that suppresses noise in playing pauses without affecting the tonal
quality of the sound. Also allows adjusting the mixing balance and level of the DRIVE/SYNTH module.
ZNRoF, Z0 Z9MIX BALANCE 0 98, 1.0LEVEL2 98, 1.0
Adjusts the mixing balance
between the signal before input to
the DRIVE/SYNTH module and
Adjusts the ZNR sensitivity. For Adjusts the signal level after passing the
the signal after passing the
maximum noise reduction, set the value DRIVE/SYNTH module. When the
module. Higher setting values
as high as possible without causing the DRIVE/SYNTH module is set to Off,
result in stronger WET sound.
sound to cut in or decay unnaturally. the indication "oF" is shown.
When the DRIVE/SYNTH
module is set to Off, the
indication "oF" is shown.
LO EQ
LO EQ module
This is an equalizer for the low frequency range. You can select either a 3-band equalizer
or parametric equalizer.
LELELO EQ (Low EQ)
This is a 3-band equalizer that adjusts the frequency range below 450 Hz.
70Hz12150Hz12450Hz12
70 Hz, shelving type equalizer. 150 Hz, peaking type equalizer. 450 Hz, peaking type equalizer.
LPLPLO PARAMETRIC EQ (Low Parametric EQ)
This is a parametric equalizer that adjusts the frequency range below 650 Hz.
TYPE1, 2, SHFREQUENCYSee Table 1GAIN12
Selects the type of Ţlter. "1" gives a
peaking type Ţlter with narrow Q, "2"
Selects a frequency within the range of
gives a peaking type Ţlter with wide Q, Adjusts the gain.
100 - 650 Hz.
and "SH" produces a shelving type LO
EQ.
Table 1
DisplayFrequencyDisplay Frequency
10100Hz50500Hz
25250Hz65650Hz
35350Hz
ZOOM B226