UX-510TH
FO-1460TH
Loading paperInstalling the imaging film
1. Insert the paper tray into the fax if1. Press the release marked OPEN
not yet installed.and open the print compartment
cover.
2. Insert two of the gears into the
ends of the spool with film.
2. Remove the paper cover if it is on
the tray. (For legal paper, flip up
the tray externder.)
3. Hold the empty spool so that the
end with only one slot is on the
left, and lower the spools into the
printing compartment so that the
gears fit into the slots on each side
of the compartment.
4. Cut the band holding the spools
together with scissors, and re-
move it. Insert the remaining gear
3. Pull the paper release plate to-
into the right end of the empty
ward you.
spool and the flange into the left
¨ If any paper remains in the tray,end of the empty spool.
take it out and combine it into a
single stack with the new paper.
5. Pull the empty spool toward the
back of the compartment, un-
winding the leader from the spool
with film. Insert the empty spool
into the compartment so that gear
and spool fit into the slots on each
side of the compartment.
4. Insert the stack of paper into the
tray. Replace the tray cover and
then push the paper release plate
back down.
6. Wind the film slightly to remove
slack and then close the printer
compartment cover.
5. Press the following sequence of
keys:FUNCTION
67. If you replaced the film. press the
following sequence of keys (this
is not necessary for the sample
Press "1" if you loaded letter size
film included with the fax):
paper, or "2" if you loaded legal
size paper.START
STOPFUNCTION
When finished, press:6
1 � 10 |
ACEC
SHARP
