NOTE: Drying will continue from where the cycle was interrupted
Starting Electronic Modelsif you close the door and press START within 5 minutes. If the
cycle is interrupted for more than 5 minutes, the dryer will shut off.
1. Load clothes loosely into the dryer and close the door. Do not You will need to select new cycle settings before restarting the
pack the dryer. Allow space for clothes to tumble freely.dryer.
2. Select one of the Automatic or Timed Cycles.
Use the Heavy Duty, Towels/Cotton or Normal cycles to
Drying Rack
dry most heavyweight and medium weight fabrics.
Use the Drying Rack to dry items such as sweaters and pillows
If you select an Automatic Cycle, you may change the
without tumbling. The drum turns, but the rack does not move.
dryness level. Press the plus (+) or minus (-) pads for
MORE DRY or LESS DRY. NOTE: The rack must be removed for normal tumbling. Do not
use the automatic cycle with the drying rack.
If you select a Timed Cycle, you may change the time and
To use the drying rack
temperature settings. To change the time, press the plus
(+) or minus (-) pads to get MORE TIME or LESS TIME. To 1. Place drying rack in dryer.
change the temperature press the TIMED CYCLES TEMP
Style 1: Your drying rack has front legs. Slide rear pegs into
pad.
the dimples on the back wall of the dryer. Lower the front legs
3. Select the WRINKLE SHIELD? setting, if desired. When you to rest on the dryer opening.
are unable to remove a load from the dryer as soon as it stops,
Style 2: Your drying rack does not have front legs. Do not
wrinkles can form. This feature periodically tumbles,
remove the lint screen. Slide drying rack over the bottom of
rearranges and fluffs the load without heat to help avoid
the dryer door opening. Push down to secure rack on frame.
wrinkling.
2. Put wet items on top of rack, leaving space between items.
4. Select the CYCLE SIGNAL, if desired. The signal is helpful
Do not allow items to hang over the edge of the rack. Close
when drying items that should be removed from the dryer as
the door.
soon as it stops.
3. Select a timed drying cycle and temperature, or an air cycle.
5. If desired, add fabric softener sheet. Follow package
Items containing foam, rubber, or plastic must be dried on a
instructions.
clothesline or by using an air cycle. Refer to the following
6. Push the START pad. table.
4. Start the dryer. Reset cycle to complete drying, if needed.
Stopping, Pausing and Restarting
You can stop your dryer anytime during a cycle.Rack DryCycleTempTime
To stop your dryer
Washable wool items (block TimedLow60 min.
Press PAUSE/CANCEL twice.
to shape, lay flat on rack)Drying
To restart your dryer
Close the door. Select a new cycle and temperature (if desired). Stuffed toys/pillows (cotton TimedLow60 min.
Push the START pad.or polyester filled)Drying
To pause your dryer
Stuffed toys/pillowsAir N/A90 min.
Open the door or press PAUSE/CANCEL once. Close the door Foam rubber filled(no heat)
and press START to resume the cycle.
DRYER CARE
Cleaning the Dryer LocationCleaning the Lint Screen
Keep dryer area clear and free from items that would obstruct the Clean the lint screen before each load. A screen blocked by lint
flow of combustion and ventilation air.can increase drying time.
IMPORTANT:
Do not run the dryer with the lint screen loose, damaged,
WARNING
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint.
Every Load Cleaning
Explosion HazardStyle 1:
1. The lint screen is located on top of the dryer. Pull the lint
Keep flammable materials and vapors, such as
screen toward you. Roll lint off the screen with your fingers.
gasoline, away from dryer.
Do not rinse or wash screen to remove lint. Wet lint is hard to
Place dryer at least 18 inches (46 cm) above the floorremove.
for a garage installation.2. Push the lint screen firmly back into place.
Style 2:
Failure to do so can result in death, explosion, or fire.
1. The lint screen is located in the door of the dryer. Pull the lint
screen straight up. Roll lint off the screen with your fingers. Do
not rinse or wash screen to remove lint. Wet lint is hard to
remove.
2. Push the lint screen firmly back into place.
5 |
ACEC
WHIRLPOOL
