DCR-TRV738E/TRV740/TRV740E/TRV840
Ver 1.2 2002. 09
2. Flange Back AdjustmentAdjusting method:
(Using Minipattern Box)Order Page Address DataProcedure
The inner focus lens flange back adjustment is carried out
100101Set the data.
automatically. In whichever case, the focus will be deviated during
auto focusing/manual focusing.260113Set the data, and press PAUSE
SubjectSiemens star chart with ND filter forbutton.
the minipattern box (Note1)360127Set the data, and press PAUSE
button.
Measuring Instrument Adjustment remote commander
4602Check that the data changes to
Adjustment PageFO01�. (Note6)
Adjustment Address48 to 58
Note6: The adjustment data will be automatically input to page: F, address:
Note1: Dark Siemens star chart.48 to 58.
Note2: This adjustment should be carried out upon completion of OHALL
adjustment�.Processing after Completing Adjustments:
Note3: Make the lens horizontal and perform this adjustment.
Note4: The data of page: 0, address: 10 must be O00�.Order Page Address DataProcedure
Note5: Check that the data of page: 6, address: 02 is O00�. If not, to page:100100Set the data.
6, address: 01, set data:00, and press the PAUSE button.
2Turn off the power and turn on
Switch setting:again.
1) POWER..................................................................3Perform OFlange Back Check�.CAMERA
2) NIGHT SHOT ..................................................................OFF
3) COLOR SLOW SHUTTER .............................................OFF
Preparations:
1) The minipattern box is installed as shown in the following
figure.
Note: The attachment lenses are not used.
2) Install the minipattern box so that the distance between it and
the front of the lens of the camcorder is less than 3cm.
3) Make the height of the minipattern box and the camcorder equal.
4) Check that the output voltage of the regulated power supply is
the specified voltage.
5) Check that at both the zoom lens TELE end and WIDE end,
the center of the Siemens star chart and center of the exposure
screen coincide.
Specified voltage: The specified voltage varies according to the
minipattern box, so adjust the power supply
output voltage to the specified voltage written
on the sheet which is supplied with the
minipattern box.
Below 3 cm
Minipattern box
Camcorder
Camera
table
Regulated power supply
Output voltage : Specified voltage ?0.01Vdc
Output current : more than 3.5A
Red (+)
Black (�)
Yellow (SENS +)
White (SENS �)Need not connected
Black (GND)
Fig. 5-1-7.
5-21 |