A1215_ifu.qxp 5/13/2005 10:56 AM Page 15
English11221155
CLEANING THE FILTERS
DESCRIPTION OF PARTSMenalux branded filters are strongly recommended by Progress. Those high quality filters will ensure a long lifetime of your Progress vacuum cleaner.
1. Suction inlet9. HoseFor more information about Menalux products, please visit our website : www.menalux.com.
2. Suction power regulator10. Plastic tubesIf suction appears to be reduced when cleaning, please check filters as this is an indication that they require cleaning.
3. On/off switch11. Dual purpose floor nozzleThe dustbin filter must be cleaned when causing reduced suction.
4. Cable rewind button12. Crevice nozzleFilters should be replaced at least twice a year.
5. Wheel13. Upholstery nozzleAlways operate the cleaner with filters installed to avoid reduced suction.
6. Dustbin14. Dustbin filterDisconnect from electrical outlet before changing the filters.
7. Carrying handle15. Vertical parking
8. Dustbin open button16. Horizontal parkingCleaning the dustbin filter
ORemove the dustbin by pushing the button at the end of the carrying handle (fig. 17).
Ofig.20
OLet the filter dry. Avoid direct sunlight and extreme drying circumstances (hair-dryer, etc.) (fig. 21).
OInsert the dustbin filter back into the dustbin (fig. 18).
IMPORTANT SAFEGUARDSOInsert the dustbin back into the cleaner by pushing it until it clicks (fig. 17).
O Read this instruction booklet carefully.Dustbin filter reference number: ANC 407 136 316/4
O Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate.
O Do not switch the appliance on if it appears to be faulty in any way. Cleaning the motor filter
O Do not try to repair the appliance by yourself. For repairs or accessories, contact your customer service.Ofig. 22
O Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations.Ofig.24
O Never leave the appliance unattended when it is switched on. Keep the appliance out of reach of children.OLet the filter dry. Avoid direct sunlight and extreme drying circumstances (hair-dryer, etc.) (fig. 21).
O This appliance is for domestic use only. Use as described in this instruction booklet.Ofig. 23
O Do not pull the appliance by the cord. Do not unplug by pulling on the cord. Do not use the cleaner with a damaged cable. If the cable is damaged, itOfig. 22
should be replaced at a service center. This is not covered by the warranty.Cleaning the exhaust filter
O Do not use appliance on wet surfaces or to vacuum liquids, mud, ash and burning cigarette butts. Do not vacuum up any highly flammable or explosiveOOfig. 25
substances or gases. Do not vacuum fine dust from plaster, concrete, flour or ash. The above can cause serious damage to the motor damageOfig. 26
which is not covered by the warranty.Ofig.24
O Do not unplug the vacuum cleaner with wet hands.OLet the filter dry. Avoid direct sunlight and extreme drying circumstances (hair-dryer, etc.) (fig. 21).
O Do not operate the vacuum cleaner too close to heaters and radiators, stoves etc.Ofig. 26
O Before you start using the vacuum cleaner, please remove large or sharp objects from the floor to prevent damage to the dust bin and hose.Ofig. 25
INSTRUCTIONS FOR USE RECOMMENDED FILTERS
O Before placing into operation make certain that the filters and the dustbin are in the proper position.- Menalux Motor Filter: D24.
O Unwind a sufficient length of cable and insert the plug into the power socket. AYELLOW mark on the power cable shows the ideal cable length. Do not- Menalux Exhaust Filter : D09.
extend the cable beyond the RED mark.PROTECTING THE ENVIRONMENT
O Press the ON/OFF button to switch the appliance on. On initial start up full power is reached after approximately 1-2 seconds.OAttempt to recycle packaging material and old appliances.
O To rewind the power cable, press the rewind button with foot, and guide the cable with hand to ensure that it does not whip causing damage.OThe cardboard packaging can be placed in the waste paper collection.
O Rotate suction control knob clockwise to increase suction and anticlockwise to reduce suction.ODeposit the polystyrene foam at the PS collection point for recycling.
Recycling the Appliance at the end of its life
MAINTENANCEOThe plastic components all carry a material identification marking so that, like the other materials, they can recycled at the end of the life of the appli-
ance.
OPlease inquire with your local authority.
REMOVING THE CONTENTS OF THE DUSTBINBlocked air flow and dirty filters
Always operate the cleaner with the dustbin installed.OThe cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt.
The dustbin must be emptied when visibly full.ODisconnect from mains and allow the cleaner to cool for 20-30 minutes. Remove blockage and/or clean filters.
ORestart the cleaner.
O fig. 17
O fig. 18The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over
O fig. 19to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help pre-
O Insert the dustbin filter back into the dustbin. (fig. 18).vent potential negative consequences for the environment and human health, whic could otherwise be caused by inappropriate waste handling of this
O Insert the dustbin back into the cleaner by pushing it until it clicks. fig. 17product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the
shop where you purchased the product.
6 5 |