3.1.9 Displaying battery voltage
The battery voltage can be displayed as follows:
1Call up the BATT VOLT screen.
108&3Press the F key, and then
'SET
.1.40/*4&5press the HELP key with #"5 5 70 - 5
42-70-shown on the display.4.9V
3$)7'40.3.8
"#The BATT VOLT menu will
-"
1appear. Point the arrow at +CONFIG using the dial or.
%08/61TF
UP/DOWN key, and then press the ENT key. The
4&5
55HELPCONFIG menu will appear. Point the arrow at +BATT"
.0%&45&13/".&
.
12,-RF CVOLT using the dial or UP/DOWN key, and then press
*$.8."650"#4TF
the key.ENT
The battery voltage will be shown on the display.
SKIP
If you press the CLR key, the battery voltage
disappears.
Note: � The measured value is updated every 0.5 second.
� If an external power source (10-16 V) is used, �OVER 8V� is displayed.
3.1.10 Setting the reception tone
The reception tone can be set to either of 2 levels as follows:
1Call up the TONE screen.
108&3Press the F key, and then press
'SET
.1.40/4&5the key HELPwith shown on*TONE
42-70-the display.High
43$)7'0.3.8LOW
"#The TONE menu will appear.
-"
1.
Point the arrow at +CONFIG using the dial or UP/DOWN
%08/61TF
key, and then press the ENT key.
4&5
5HELPThe CONFIG menu will appear. Point the arrow at"5
.0%&45&13./".&TF
12,-RF C+TONE and then press the ENTkey.
$8.*.4"650"#
2Set the reception tone.
Point the arrow at Highor Low using the dial or UP/DOWN key, and then press
TF
the ENT key (the initial setting is High).
The display will return to the CONFIG menu. Point the arrow at END and then
TF
press the ENT key (Alternatively, you may press the F key, and then press the
TFkey with shown on the display).
ENT
SKIP
Note: If you exit the CONFIG menu by pressing the CLR key, the changed setting
is canceled.
39 |