T6310EZ-I(EN).qx3 02.4.10 11:16 AM Page 15
9. Before you call an engineer
If, contrary to expectation, you have any problems using this TV-Video Combi, it may be caused by the fol-
lowing reasons.
Your TV-Video Combi does not respond to any<14PV203/07, 14PV460/07>
button being pressed:*OPDCO switched on but �PDC timeO wrong: Enter
*There is no power supply: check the power supply.�PDC timeO exactly to the minute. Check your
*Parental control is on:Switch the parental control off.aerial connection.
*There is a technical problem: disconnect from theSmart Clock does not work
mains power supply for 5 minutes, then power-up*You have stored on programme number �P01O a
again.TV channel that does not transmit TELETEXT.
If this doesn't help, you can reset your TV-VideoStore on �P01O a TV channel that transmits
Combi to default factory settings.TELETEXT.
Resetting devices to default factory settings*Poor TELETEXT reception. Store a TV channel
*Warning: by doing so you will the informationon �P01O with good TELETEXT reception.
stored (TV channels, time and date, TIMER)*You have not activated the Smart Clock func-
will be cleared.tion. Switch the function �ONO.
1.Switch the TV-Video Combi to stand-by.
2.Press and hold RECORD and P - at theYou can also call the customer service centre
same time for 2 seconds or more.in your country.The telephone numbers can be
Cassette is jammed in the TV-Video Combifound on the back of this instruction manual.
*DonOt use force. Disconnect the set from theHave the model number (MODEL NO) and the
mains and reconnect it again after a few sec-production number (PROD.NO.) of your TV-
onds.Video Combiready.
Remote control does not work
*Remote control is not pointed at the TV-Video
Combi.
*Take out the batteries, wait for 10 seconds and
place them back in the remote control.
*Batteries have run out. Change the batteries.
No picture when you play a cassette
*There is no recording on the cassette.
Poor picture quality when you play a cas-
sette
*The cassette is badly worn-out or of poor qual-
ity. Use a new cassette.
*Tracking is not properly adjusted. Turn to sec-
tion �Manual TrackingO.
No recording possible
*The TV channel you want to record is not
stored or you selected the wrong programme
number: check TV channels stored.
*A cassette was inserted that does not have the
security tab (cannot be used to record): Insert
a cassette with an intact security tab or change
cassette. For more information, please see the
section �Preventing accidental erasing of cas-
settesO in chapter �Manual RecordingO.
15ENEN |
ACEC
PHILIPS
