PAL I(EN).qx3 02.4.2 6:42 PM Page 3
1. Connecting the TV-Video Combi
1.1.Take the remote control and the enclosed
Important for the United Kingdom
batteries (2 batteries).
This apparatus is fitted with an approved 5 Amp plug.2.2.Open the remote control's battery compart-
To change a fuse in this type of plug proceed as fol-ment and place the batteries in it as shown in
lows:the picture and close the battery compart-
1.1.Remove fuse cover and fuse.ment.
The remote control is now ready to use.
2.2.Fix new fuse which should be a BS1362
Its range is approximately 7 metres.
5A,ASTA or BSI approved type.
3.3.Refit the fuse cover.Connecting the cable
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should
have a value of 5A. If a plug without a fuse is
used, the fuse at the distribution board should
not be greater than 5A.
The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a
13A socket elsewhere.
How to connect a plug:1.1.Insert the aerial cable plug into the AERIAL
The wires in the mains lead are coloured inat the back of the TV-Video Combi.
accordance with the following code:2.2.Connect the mains cable to the wall socket.
BLUE- 'NEUTRAL' ('N')3.3.If the little red standby light (STANDBY ) at
BROWN- 'LIVE' ('L')
the front panel of the set is not lit, please
4.4.The BLUE wire must be connected to the ter-
switch on the set using the main power
minal which is marked with the letter 'N' orswitch. The power switch is located on the
coloured BLACK.
left side panel of the set.
5.5.The BROWN wire must be connected to theThis text will appear on the TV screen.
terminal which is marked with the letter 'L' or
PLEASE CONNECT AERIAL OR
coloured RED.CABLE TO THE TVCR
6.6.Do not connect either wires to the earth ter-
minai in the plug which is marked with the let-THEN...
PUSH P+ KEY
ter 'E' or by the safety earth symbol or
coloured green or green-and-yellow.OR...
Before replacing the plug cover, make certainFOR PLAY ONLY PUSH PLAY
that the cord grip is clamped over the sheath of
the lead-not imply over the two wires.You can find more details in chapter 'Preparation
for use'.
Connecting additional devices
Preparing the remote control for
operationYou can connect additional devices such as
decoders, satellite receivers, camcorders, etc. to
The remote control and its batteries are packed sepa-the EXT1 socket.
rately in the original TV-Video Combi packaging.You
must install the batteries in the remote control before
use.
The respective scart socket is usually marked
'AV' or 'TV' on the decoder or satellite receiver.
3EN |
ACEC
PHILIPS
