Guided Tour - Model 3500 Rear Panel
5. Effect Send jack - Use this 1/4� unbalanced jack to send low impedance
(600 ohm) signal from the Model 3500 to a professional outboard effects proces-
sor such as a reverb, echo, chorus, flanger, or harmonizer device.* Output level
is approximately 0 dB to +4 dB and is post-EQ and post-compression but
unaffected by the setting of the Master Volume control. You can also use the
Effect Send jack to route signal to an external mixing console or amplifier with an
input sensitivity of +4 dB.
6. Effect Return jack- Use this 1/4� unbalanced jack to return low impedance
(600 ohm) signal to the Model 3500 from a professional outboard effects
processor.*
7. Balance control - Use this to adjust the relative amount of Effect Send (dry)
versus Effect Return (wet) signal being routed to the Model 3500 speaker
outputs. At the center-detented O0� position, equal amounts of Send and Return
signal are routed. At its fully counterclockwise (OSend�) position, no signal from
a connected effects processor(s) is added to the main output. At its fully clock-
wise (OReturn�) position, the only signal you hear is that coming from a connect-
ed outboard effects processor(s). If your outboard effects processor has an
adjustable wet/dry control, we recommend that you set the Balance knob to its
fully clockwise (OReturn�) position and use the effects processorOs wet/dry control
to adjust the relative mix. Alternatively, you can set the effects processor to
output fully Owet� signal and use the Model 3500 Balance knob to adjust the
relative mix of dry vs. wet signal
8. Direct Out Post/Pre switch- When pressed in (the OPre� position), signal is
routed to the Direct Out jack prior to the Model 3500 ten-band graphic equalizer
(but after the compression circuitry and Contour controls). When out (the OPost�
position), signal is routed to the Direct Out jack after all compression and EQ
circuitry (both ten-band graphic and Contour).** Use the OPre� position when
you want the console engineer to have control over equalizing your bass signal;
use the OPost� position when you want to use the front panel ten-band graphic
equalizer to equalize your bass signal before sending it to the console.
9. Direct Out Normal/Ground Lift switch- When pressed in (the OGnd. Lift�
position), pin 1 is removed from the chassis. This should be used only when a
ground loop hum or buzz is heard; otherwise, leave it in the out (ONormal�)
position.
10. Direct Out jack- Use this electronically balanced XLR jack to route signal
from the Model 3500 to a professional mixing console or as a tap to a main PA
system via a mic input on the console. The signal output from this jack is low
impedance (600 ohm) with an output level of approximately -30 to -20 dB. You
can also use the Direct Out jack to route signal to an external amplifier with a
-10 dB input sensitivity.
* In-line effects (such as footpedals) intended for low signal levels should be
placed between the bass and the amplifier Input and not connected with the
Effect Send and Return jacks.
** Note that the settings of the ten-band graphic equalizer will affect a OPost�
Direct Out signal regardless of the position of the front panel In/Out switch.
12 |
ACEC
HARMAN
