MAINTENANCE
Spark plugLubricating the flexible drive axle
The condition of the spark plugInside the edger�s drive shaft
is affected by:is a flexible drive axle. The
flexible drive axle should be
Y An incorrect carburettorregularly lubricated after 30
setting.0,5 mmhours of operation. Loosen the
Y An incorrect fuel mixture (tootwo screws on the angle gear
much or faulty oil).and remove it. The flexible
Y A dirty air filter.drive axle is easily removed
from the shaft by taking a firm
These factors cause depositsgrip on the axle end. Lubricate
on the spark plug electrodethe flexible drive axle over its
that may result in malfunctionentire length and reinsert it in
or starting difficulties.the shaft. Turn the axle while
inserting it so that it correctly
engages in the clutch. Replace
the angle gear on the drive
axle shaft and tighten the two
If the machine is low on power, difficult to start or runsscrews.
poorly while idling always check the spark plug first before
taking any other action.
If the spark plug is dirty, clean it and at the same time check
that the electrode gap is 0.5 mm. The spark plug should be
changed after about one month of operation or earlier if
necessary.
NOTE! Always use the recommended type of spark plug. An
incorrect spark plug can damage the cylinder/piston.
Adjusting the edger's cutting depth
The cutting depth should be
adjusted before starting work.
Angle gearY Loosen the locking handle
(A) and rotate the guard by
moving the locking knob
The angle gear is filledforwards or backwards. If the
a sufficient quantity of grease
at the factory. However, beforelocking handle is moved
using the machine you shouldforwards (from the machine)
check that the angle gear isthe cutting depth isA
increased. If the locking
filled to 3/4 with grease. Usehandle is moved backwards
HUSQVARNA special grease.(towards the machine) the
cutting depth is reduced.
Normally, the grease does not
need to be changed except
when repairs are carried out.Y Adjust the cutting depth.
Y Lock the locking handle.
WARNING!
Always bear the machine on the right side of
!the body. Always wear protective glasses,
long trousers and heavy-duty shoes when
using the machine. Observe your
surroundings, ensure people and animals do
not come in the immediate vicinity or can be
hit by thrown objects. Apply full throttle
before the blade starts to work on the soil.
English � 19
Eng-5 225E NY1997-03-24, 14.07 |
ACEC
HUSQVARNA
