ASSEMBLY
Fitting a blade guard, grass blade Fitting other guards and cutting
and grass cutterattachments
GY Fit the trimmer guard/combination guard (A) intended for
Fuse with the trimmer head/plastic blades. CAUTION!
Ensure that the guard extension is Ţtted.
E
Hang the trimmer guard/combination guard (A) on the two
D
hooks on the plate holder (M). Bend the guard around the
shaft and tighten it with the bolt (L) on the opposite side of
the shaft. Use the locking pin (C). Place the locking pin in
the groove on the screw head and tighten. See diagram.
B
AC
L
M
AC
Y Hook the blade guard/combination guard (A) onto the
Å¢tting on the shaft and secure with the bolt. CAUTION! A
Ensure that the guard extension is removed.
Y Fit the drive disc (B) on the output shaft.
Use the recommended blade guard. See the Technical
data section.
H
Y Fit the drive disc (B) on the output shaft.
Y Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
A
Y Insert the locking pin (C) in the hole to lock the shaft.B
Y Place the blade (D), support cup (E) and support �ange
(F) on the output shaft.
M
L
Y Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool Y Turn the blade shaft until one of the holes in the drive disc
kit. Hold the shaft of the spanner as close to the blade aligns with the corresponding hole in the gear housing.
guard as possible. To tighten the nut, turn the spanner in
Y Insert the locking pin (C) in the hole to lock the shaft.
the opposite direction to the direction of rotation (Caution!
left-hand thread). Y Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
Y To dismantle, follow the instructions in the reverse order.
12 � English |
ACEC
HUSQVARNA
